Exmark 4500-370 manual Thread Locking Adhesives

Page 17

Maintenance

spacer nuts to the axle. Remove the axle (with the other spacer nut still assembled to it) from the wheel assembly.

5.Pry out seals, and inspect bearings for wear or damage and replace if necessary.

6.Pack the bearings with a NGLI grade #1 multi-purpose grease.

7.Insert one bearing, one new seal into the wheel.

Note: Seals (Exmark PN 103-0063) must be replaced.

8.If the axle assembly has had both spacer nuts removed (or broken loose), apply a thread locking adhesive to one spacer nut and thread onto the axle with the wrench flats facing outward. Do Not thread spacer nut all of the way onto the end of the axle. Leave approximately 1/8 inch (3 mm) from the outer surface of the spacer nut to the end of the axle inside the nut.

9.Insert the assembled nut and axle into the wheel on the side of the wheel with the new seal and bearing.

10.With the open end of the wheel facing up, fill the area inside the wheel around the axle full of NGLI grade #1 multi-purpose grease.

11.Insert the second bearing and new seal into the wheel.

12.Apply a thread locking adhesive to the 2nd spacer nut and thread onto the axle with the wrench flats facing outward.

13.Torque the nut to 75-80 in-lb (8-9 N-m), loosen, then re-torque to 20-25 in-lb (2-3 N-m). Make sure axle does not extend beyond either nut.

14.Reinstall the seal guards over the wheel hub and insert wheel into caster fork. Reinstall caster bolt and tighten nut fully.

Important: To prevent seal and bearing damage, check the bearing adjustment often. Spin the caster tire. The tire should not spin freely (more than 1 or 2 revolutions) or have any side play. If the wheel spins freely, adjust torque on spacer nut until there is a slight amount of drag. Reapply thread locking adhesive.

Thread Locking Adhesives

Thread locking adhesives such as “Loctite 242” or “Fel-Pro, Pro-Lock Nut Type” are used on the following fasteners:

Caster wheel spacer nuts.

17

Image 17
Contents CD42CD/CD48CD All Rights Reserved Introduction Contents Safe Operating Practices SafetySafety Alert Symbol Maintenance and Storage Safety and Instructional Decals Dimensions SpecificationsModel Numbers SystemsAssemble Deck to Navigator SetupDeck Removal Raising the Mower Deck into Service Position Adjusting the Cutting HeightProduct Overview OperationLowering the Mower Deck to the Operating Position Adjusting Fill Reduction System FRS BafflesOperation Check Mower Blades MaintenanceChange Gearbox Oil Check for Loose HardwareCheck Tire Pressures Lubricate Caster Wheel Hubs Lubricate Grease FittingsThread Locking Adhesives Deck Leveling Deck Locking Pin Stop AdjustmentCaster Pivot Bearings Pre-load Adjustment Clean Grass Build-Up Under Deck Clean Debris From Cutting DeckProblem Possible Cause Corrective Action TroubleshootingExmark Commercial Turf Equipment Service Record Page See EXMARK’S Complete Line of Accessories and Options