Husqvarna 327P5X manual Filling with oil, Assembling and dismantling the two-piece shaft, Assembly

Page 16

ASSEMBLY

Filling with oil

•Open the cap on top of the bar head

•Fill with Husqvarna saw chain oil.

•Reﬁt the cap.

Assembling and dismantling the two-piece shaft

(327P5)

Assembly:

•Loosen the coupling by turning the knob.

•Align the tab of the attachment (A) with the arrow on the coupling (B).

B

A

•Push the attachment into the coupling until the attachment snaps into place.

•Before using the unit, tighten the knob securely.

Dismantling:

Loosen the coupling by turning the knob (at least 3 times).

•Push and hold the button (C). While securely holding the engine end, pull the attachment straight out of the coupling.

C

Fitting the impact guard

(327P5)

If the machine has a protective guard bolted under the engine this should be removed before the impact guard is assembled.

Fit the guard using the three screws and washers. Fit the two short screws in hole A. Tighten the screws to a torque

16 – English

Image 16

Contents 327P4 327P5X-series KEY to Symbols SymbolsContents Introduction Dear CustomerWhat is WHAT? What is what?General Safety Precautions Personal protective equipmentMachine′s safety equipment Throttle lockoutVibration damping system Stop switchMufﬂer Quick release Balance Flex harness Cutting equipmentSpeciﬁcation of bar and saw chain Sharpening your chain and adjusting raker clearanceChain Increases the risk of kickback General advice on setting raker clearanceSharpening cutting teeth Setting the raker clearance Tensioning the chainIncreased if the raker clearance is too LargeLubricating cutting equipment Chain drive sprocket Checking wear on cutting equipment ChainMay increase the risk of accidents Assembly Adjusting the harnessFitting the cutting head Fitting the bar and chainAssembly Filling with oilAssembling and dismantling the two-piece shaft Fitting the impact guardAssembly of the saw attachment Fuel Handling Fuel safetyFuel Fuelling MixingMufﬂer gets very hot during and after Use. This also applies during idling. BeStarting and Stopping Check before startingStarting and stopping StartingStopping Safety instructions regarding the surroundings Safety instructions while workingWorking Techniques General working instructionsSafety instructions after completing work Basic working techniquesWithout having the cutting attachment in full view Carburettor MaintenanceMufﬂer Spark plug Cooling systemIs damaged it should be replaced Cleaning the air ﬁlter Two-piece shaftAir ﬁlter Oiling the air ﬁlterMaintenance schedule Maintenance Daily Weekly MonthlyTechnical Data Technical dataEC-declaration of conformity Applies to Europe only Approved accessories Art No Use withBar and chain combinations Page Page Page Page Page Original instructions 1153303-26