Husqvarna 327P5X manual Technical Data, Technical data

Page 29

TECHNICAL DATA

Technical data

 

327P4

327P5

Engine

 

 

Cylinder displacement, cm3

24,5

24,5

Cylinder bore, mm

34

34

Stroke, mm

27

27

Recommended max. speed, rpm

11500-12500

11500-12500

Idle speed, rpm

2700

2700

Max. engine output, acc. to ISO 8893, kW/ rpm

0,9/8400

0,9/8400

Catalytic converter muffler

Yes

Yes

Speed-regulated ignition system

Yes

Yes

Ignition system

 

 

Spark plug

Champion RCJ 6Y

Champion RCJ 6Y

Electrode gap, mm

0,5

0,5

Fuel and lubrication system

 

 

Fuel tank capacity, litre

0,5

0,5

Weight

 

 

Weight without fuel, kg

6,1

Noise emissions

 

Equivalent sound power level, measured according to

105

EN ISO 22868, dB(A)

 

Sound levels

 

(see note 1)

 

Equivalent sound pressure level at the operator’s ear,

95

measured according to EN ISO 22868, dB(A):

 

Vibration levels (see note 2)

Equivalent vibration levels (ahv,eq) at handles, measured according to EN ISO 22867, m/s2

6,4

105

86

Front/rear handles:

2,9/2,8

3,4/1,9

Note 1: Reported data for equivalent sound pressure level for the machine has a typical statistical dispersion (standard deviation) of 1 dB (A).

Note 2: Reported data for equivalent vibration level has a typical statistical dispersion (standard deviation) of 1 m/s2.

English – 29

Image 29
Contents 327P4 327P5X-series Symbols KEY to SymbolsContents Dear Customer IntroductionWhat is what? What is WHAT?Personal protective equipment General Safety PrecautionsThrottle lockout Machine′s safety equipmentMuffler Stop switchVibration damping system Cutting equipment Quick release Balance Flex harnessChain Sharpening your chain and adjusting raker clearanceSpecification of bar and saw chain Sharpening cutting teeth General advice on setting raker clearanceIncreases the risk of kickback Tensioning the chain Setting the raker clearanceIncreased if the raker clearance is too LargeLubricating cutting equipment May increase the risk of accidents Checking wear on cutting equipment ChainChain drive sprocket Adjusting the harness AssemblyFitting the cutting head Fitting the bar and chainFilling with oil AssemblyAssembling and dismantling the two-piece shaft Fitting the impact guardAssembly of the saw attachment Fuel Fuel safetyFuel Handling Mixing FuellingMuffler gets very hot during and after Use. This also applies during idling. BeCheck before starting Starting and StoppingStarting and stopping StartingStopping Safety instructions while working Safety instructions regarding the surroundingsWorking Techniques General working instructionsBasic working techniques Safety instructions after completing workWithout having the cutting attachment in full view Muffler MaintenanceCarburettor Is damaged it should be replaced Cooling systemSpark plug Two-piece shaft Cleaning the air filterAir filter Oiling the air filterMaintenance Daily Weekly Monthly Maintenance scheduleTechnical data Technical DataBar and chain combinations Approved accessories Art No Use withEC-declaration of conformity Applies to Europe only Page Page Page Page Page Original instructions 1153303-26