Husqvarna 327P5X manual Original instructions 1153303-26

Page 36

Original instructions

1153303-26

´®z+U>@¶6•¨ ´®z+U>@¶6•¨ 2011-09-02

Image 36

Contents 327P4 327P5X-series KEY to Symbols SymbolsContents Introduction Dear CustomerWhat is WHAT? What is what?General Safety Precautions Personal protective equipmentMachine′s safety equipment Throttle lockoutStop switch Vibration damping systemMufﬂer Quick release Balance Flex harness Cutting equipmentSharpening your chain and adjusting raker clearance Speciﬁcation of bar and saw chainChain General advice on setting raker clearance Increases the risk of kickbackSharpening cutting teeth Setting the raker clearance Tensioning the chainIncreased if the raker clearance is too LargeLubricating cutting equipment Checking wear on cutting equipment Chain Chain drive sprocketMay increase the risk of accidents Assembly Adjusting the harnessFitting the cutting head Fitting the bar and chainAssembly Filling with oilAssembling and dismantling the two-piece shaft Fitting the impact guardAssembly of the saw attachment Fuel safety Fuel HandlingFuel Fuelling MixingMufﬂer gets very hot during and after Use. This also applies during idling. BeStarting and Stopping Check before startingStarting and stopping StartingStopping Safety instructions regarding the surroundings Safety instructions while workingWorking Techniques General working instructionsSafety instructions after completing work Basic working techniquesWithout having the cutting attachment in full view Maintenance CarburettorMufﬂer Cooling system Spark plugIs damaged it should be replaced Cleaning the air ﬁlter Two-piece shaftAir ﬁlter Oiling the air ﬁlterMaintenance schedule Maintenance Daily Weekly MonthlyTechnical Data Technical dataApproved accessories Art No Use with EC-declaration of conformity Applies to Europe onlyBar and chain combinations Page Page Page Page Page Original instructions 1153303-26