Husqvarna 327P5X manual Two-piece shaft, Air filter, Cleaning the air filter, Oiling the air filter

Page 27

MAINTENANCE

If the machine is low on power, difficult to start or runs poorly at idle speed: always check the spark plug first before taking any further action. If the spark plug is dirty, clean it and check that the electrode gap is 0.5 mm. The spark plug should be replaced after about a month in operation or earlier if necessary.

CAUTION! Always use the recommended spark plug type! Use of the wrong spark plug can damage the piston/ cylinder. Check that the spark plug is fitted with a suppressor.

Two-piece shaft

The drive shaft end in the lower shaft should be lubricated with grease every 30 hours. There is a risk that the drive shaft ends (splined coupling) on models with two-piece shafts will seize if they are not lubricated regularly.

Air filter

The air filter must be regularly cleaned to remove dust and dirt in order to avoid:

Carburettor malfunctions

Starting problems

Loss of engine power

Unnecessary wear to engine parts.

Excessive fuel consumption.

Clean the filter every 25 hours, or more regularly if conditions are exceptionally dusty.

Cleaning the air filter

Remove the air filter cover and take out the filter. Wash it clean in warm, soapy water. Ensure that the filter is dry before refitting it.

An air filter that has been in use for a long time cannot be cleaned completely. The filter must therefore be replaced with a new one at regular intervals. A damaged air filter

must always be replaced.

If the machine is used in dusty conditions the air filter should be soaked in oil. See instructions under the heading Oiling the air filter.

Oiling the air filter

Always use HUSQVARNA filter oil, art. no. 531 00 92-48. The filter oil contains a solvent to make it spread evenly through the filter. You should therefore avoid skin contact.

Put the filter in a plastic bag and pour the filter oil over it. Knead the plastic bag to distribute the oil. Squeeze the excess oil out of the filter inside the plastic bag and pour off the excess before fitting the filter to the machine. Never use common engine oil. This would drain through the filter quite quickly and collect in the bottom.

English 27

Image 27
Contents 327P4 327P5X-series Symbols KEY to SymbolsContents Dear Customer IntroductionWhat is what? What is WHAT?Personal protective equipment General Safety PrecautionsThrottle lockout Machine′s safety equipmentStop switch Vibration damping systemMuffler Cutting equipment Quick release Balance Flex harnessSharpening your chain and adjusting raker clearance Specification of bar and saw chainChain General advice on setting raker clearance Increases the risk of kickbackSharpening cutting teeth Large Setting the raker clearanceTensioning the chain Increased if the raker clearance is tooLubricating cutting equipment Checking wear on cutting equipment Chain Chain drive sprocketMay increase the risk of accidents Fitting the bar and chain AssemblyAdjusting the harness Fitting the cutting headFitting the impact guard AssemblyFilling with oil Assembling and dismantling the two-piece shaftAssembly of the saw attachment Fuel safety Fuel HandlingFuel Use. This also applies during idling. Be FuellingMixing Muffler gets very hot during and afterStarting Starting and StoppingCheck before starting Starting and stoppingStopping General working instructions Safety instructions regarding the surroundingsSafety instructions while working Working TechniquesBasic working techniques Safety instructions after completing workWithout having the cutting attachment in full view Maintenance CarburettorMuffler Cooling system Spark plugIs damaged it should be replaced Oiling the air filter Cleaning the air filterTwo-piece shaft Air filterMaintenance Daily Weekly Monthly Maintenance scheduleTechnical data Technical DataApproved accessories Art No Use with EC-declaration of conformity Applies to Europe onlyBar and chain combinations Page Page Page Page Page Original instructions 1153303-26