Husqvarna 327P5X manual Assembly of the saw attachment

Page 17

ASSEMBLY

of 4 Nm. After the machine has been in use for around 20 hours, re-tighten the screws to 4 Nm.

Assembly of the saw attachment

(327P5)

Assembly

•Loosen the coupling by turning the knob.

•Align the tab of the attachment (A) with the arrow on the coupling (B).

•Push the attachment into the coupling until the attachment snaps into place.

•Before using the unit, tighten the knob securely.

Dismantling

•Loosen the coupling by turning the knob (at least 3 times).

•Push and hold the button (C). While securely holding the engine end, pull the attachment straight out of the coupling.

English – 17

Image 17

Contents 327P4 327P5X-series Symbols KEY to SymbolsContents Dear Customer IntroductionWhat is what? What is WHAT?Personal protective equipment General Safety PrecautionsThrottle lockout Machine′s safety equipmentMufﬂer Stop switchVibration damping system Cutting equipment Quick release Balance Flex harnessChain Sharpening your chain and adjusting raker clearanceSpeciﬁcation of bar and saw chain Sharpening cutting teeth General advice on setting raker clearanceIncreases the risk of kickback Tensioning the chain Setting the raker clearanceIncreased if the raker clearance is too LargeLubricating cutting equipment May increase the risk of accidents Checking wear on cutting equipment ChainChain drive sprocket Adjusting the harness AssemblyFitting the cutting head Fitting the bar and chainFilling with oil AssemblyAssembling and dismantling the two-piece shaft Fitting the impact guardAssembly of the saw attachment Fuel Fuel safetyFuel Handling Mixing FuellingMufﬂer gets very hot during and after Use. This also applies during idling. BeCheck before starting Starting and StoppingStarting and stopping StartingStopping Safety instructions while working Safety instructions regarding the surroundingsWorking Techniques General working instructionsBasic working techniques Safety instructions after completing workWithout having the cutting attachment in full view Mufﬂer MaintenanceCarburettor Is damaged it should be replaced Cooling systemSpark plug Two-piece shaft Cleaning the air ﬁlterAir ﬁlter Oiling the air ﬁlterMaintenance Daily Weekly Monthly Maintenance scheduleTechnical data Technical DataBar and chain combinations Approved accessories Art No Use withEC-declaration of conformity Applies to Europe only Page Page Page Page Page Original instructions 1153303-26