Husqvarna 327P5X manual Stopping

Page 21

STARTING AND STOPPING

Repeat pulling the cord until the engine starts. When the engine starts. return choke control to run position and apply full throttle; the throttle will automatically disengage from the start setting.

CAUTION! Do not pull the starter cord all the way out and do not let go of the starter handle when the cord is fully extended. This can damage the machine.

CAUTION! Do not put any part of your body in marked area. Contact can result in burns to the skin, or electrical shock if the spark plug cap has been damaged. Always use gloves. Do not use a machine with damaged spark plug cap.

Stopping

Stop the engine by switching off the ignition.

CAUTION! The stop switch automatically returns to the start position. In order to prevent unintentional starting, the spark plug cap must be removed from the spark plug when assembling, checking and/or performing maintenance.

English 21

Image 21
Contents 327P4 327P5X-series Symbols KEY to SymbolsContents Dear Customer IntroductionWhat is what? What is WHAT?Personal protective equipment General Safety PrecautionsThrottle lockout Machine′s safety equipmentStop switch Vibration damping systemMuffler Cutting equipment Quick release Balance Flex harnessSharpening your chain and adjusting raker clearance Specification of bar and saw chainChain General advice on setting raker clearance Increases the risk of kickbackSharpening cutting teeth Tensioning the chain Setting the raker clearanceIncreased if the raker clearance is too LargeLubricating cutting equipment Checking wear on cutting equipment Chain Chain drive sprocketMay increase the risk of accidents Adjusting the harness AssemblyFitting the cutting head Fitting the bar and chainFilling with oil AssemblyAssembling and dismantling the two-piece shaft Fitting the impact guardAssembly of the saw attachment Fuel safety Fuel HandlingFuel Mixing FuellingMuffler gets very hot during and after Use. This also applies during idling. BeCheck before starting Starting and StoppingStarting and stopping StartingStopping Safety instructions while working Safety instructions regarding the surroundingsWorking Techniques General working instructionsBasic working techniques Safety instructions after completing workWithout having the cutting attachment in full view Maintenance CarburettorMuffler Cooling system Spark plugIs damaged it should be replaced Two-piece shaft Cleaning the air filterAir filter Oiling the air filterMaintenance Daily Weekly Monthly Maintenance scheduleTechnical data Technical DataApproved accessories Art No Use with EC-declaration of conformity Applies to Europe onlyBar and chain combinations Page Page Page Page Page Original instructions 1153303-26