Husqvarna 346XPG E-tech, 353 E-tech, 353G E-tech Symbols in the operator’s manual, Epa

Page 3

KEY TO SYMBOLS

Symbols in the operator’s manual:

Switch off the engine by moving the stop switch to the STOP position before carrying out any checks or maintenance.

Always wear approved protective gloves.

Regular cleaning is required.

Visual check.

Protective goggles or a visor must be worn.

Refuelling.

Filling with oil and adjusting oil ﬂow.

The chain brake must be engaged when the chain saw is started.

WARNING! Kickback may occur when the nose or tip of the guide bar touches an object, and cause a lightning fast reverse reaction, kicking the guide bar up and towards the operator. May cause serious personal injury.

You will ﬁnd the following labels on your chain saw:

EPA I

EPA III

The Emissions Compliance Period referred to on the Emission Compliance label indicates the number of operating hours for which the engine has been shown to meet Federal emissions requirements. Category C = 50 hours, B = 125 hours, and A = 300 hours.

Maintenance, replacement, or repair of the emission control devices and system may be performed by any nonroad engine repair establishment or individual.

English – 3

Image 3

Contents Operator’s manual Symbols on the machine KEY to SymbolsEPA Symbols in the operator’s manualContents Dear customer IntroductionWhat is what on the chain saw? What is WHAT?General Safety Precautions Before using a new chain sawAlways use common sense Machine′s safety equipment Personal protective equipmentChain brake and front hand guard General Safety Precautions Chain catcher Throttle lockoutVibration damping system Stop switchCutting equipment Right hand guardChain General rulesCutting equipment designed to reduce kickback BarSharpening cutting teeth Sharpening your chain and adjusting depth gauge settingGeneral information on sharpening cutting teeth Increases the risk of kickbackLarge General advice on adjusting depth gauge settingAdjustment of depth gauge setting Tensioning the chainLubricating cutting equipment Checking wear on cutting equipment When the chain touches the operatorChain drive sprocket Needle bearing lubricationAssembly Fitting the bar and chainWorking with the chain Fuel Fuel HandlingLong-term storage Fuel safetyFueling Transport and storageWarm engine Starting and StoppingStarting and stopping Cold engineRisk StoppingGeneral working instructions Basic safety rulesWorking Techniques Before useClutch cover causing the chain to CleaningJam. Always stop the engine before Basic cutting technique TermsLimbing Safe distance Tree felling techniqueLogs are lying together. Such Or fatal injuryYour saw Felling directionClearing the trunk and preparing your retreat Training we advise you not to fell treesFelling cut Directional cutsHow to avoid kickback What is kickback?Freeing a tree that has fallen badly Cutting the trunk into logs Maintenance Carburetor adjustmentGeneral High speed jet H Correctly adjusted carburetorChecking the brake trigger Mufﬂer Starter Changing a broken or worn starter cordTensioning the recoil spring Fitting the starter Replacement of broken recoil and drive disc springsAir ﬁlter Spark plugNeedle bearing lubrication Adjustment of the oil pumpWhen making adjustments Lubricating the bar tip sprocketElectrical carburetor heating Air Injection centrifugal cleaningTemperature 0C 32F or colder Heated handlesDaily maintenance Weekly maintenance Monthly maintenance Maintenance scheduleTechnical data Technical Data058/1,5 mm Bar and chain combinationsSaw chain ﬁling and ﬁle gauges 050/1,3 mmYour Warranty Rights and Obligations Federal Emission Control Warranty StatementOther safety precautions American Standard Safety PrecautionsSafety precautions for chain saw users Kickback safety precautionsPage Original instructions 1153178-95