Husqvarna 436 LI, 536 LIXP manual KEY to Symbols, Symbols on the machine

Page 2

KEY TO SYMBOLS

Symbols on the machine:

Translation of the original Swedish operating instruction.

WARNING! Chain saws can be dangerous! Careless or incorrect use can result in serious or fatal injury to the operator or others.

Please read the operator’s manual carefully and make sure you understand the instructions before using the machine.

Always wear:

• Approved protective helmet

• Approved hearing protection

Protective goggles or a visor

This product is in accordance with applicable EC directives.

Noise emission to the environment according to the European Community’s Directive. The machine’s emission is specified in the Technical data chapter and on the label.

WARNING! Kickback may occur when the nose or tip of the guide bar touches an object, and cause a lightning fast reverse reaction, kicking the guide bar up and towards the operator. May cause serious personal injury.

Direction of rotation of the saw chain and maximum length of the guide bar.

Chain brake, activated (right) Chain brake, not activated (left)

Chain oil fill.

Environmental marking. Symbols on the product or its packaging indicate that this product cannot be handled as domestic waste. It must instead be submitted to an appropriate recycling station for the recovery of electrical and electronic equipment.

Direct current

Do not expose to rain.

Other symbols/decals on the machine refer to special certification requirements for certain markets.

Symbols on the battery and/or on the battery charger:

This product must be deposited at an appropriate recycling facility.

Li-ion

Fail-safe transformer

Use and store battery charger only indoors.

Double insulation

2 – English

Image 2
Contents 436 Li, 536 LiXP Symbols on the battery and/or on the battery charger KEY to SymbolsSymbols on the machine Symbols in the operator’s manual Contents Introduction Dear CustomerWhat is WHAT? What is what on the chain saw?General Safety Precautions General power tool safety warningsChain saw safety warnings Battery tool use and careService Causes and operator prevention of kickbackBefore using a new chain saw Always use common sense Personal protective equipmentKeypad Machine′s safety equipmentAutomatic switch off functionality Chain brake and front hand guardGeneral Safety Precautions Battery and battery charger General rules Battery charger safetyCutting equipment Cutting equipment designed to reduce kickback Sharpening your chain and adjusting depth gauge setting General information on sharpening cutting teethTensioning the chain General advice on adjusting depth gauge settingAdjustment of depth gauge setting Too largeLubricating cutting equipment LiXP436 Li Chain drive sprocket Filling with chain oilChecking chain lubrication Checking wear on cutting equipment Working with the chain AssemblyFitting the bar and chain Fitting a spike bumper Battery charger Battery HandlingBattery LED display Charging status Disposal of the battery, battery charger and machineTransport and storage Starting Starting and StoppingStarting and stopping StartingStopping Before use Basic safety rulesWorking Techniques SavEGeneral rules Handles with both hands Basic cutting techniqueNot safely controlled with one hand GeneralSafe distance Tree felling techniqueLog is supported at both ends. There is a high risk Felling directionYour saw Clearing the trunk and preparing your retreatFelling Training we advise you not to fell trees Directional cutsFreeing a tree that has fallen badly Freeing a trapped treeHow to avoid kickback What is kickback?Cutting the trunk into logs Checking the front hand guard MaintenanceGeneral Checking the inertia brake releaseLubricating the bar tip sprocket Battery connectorsPower trigger lockout Cooling system Maintenance schedule Daily maintenance Weekly maintenance Monthly maintenanceBattery charger Troubleshooting scheduleBattery Keypad Possible faults Possible actionTechnical Data Technical dataApplies to Europe only Guide bar and saw chain combinationsSaw chain filing and file gauges EC-declaration of conformity Page Page 1154476-26