Husqvarna 536 LIXP, 436 LI manual Troubleshooting schedule, Battery charger

Page 39

MAINTENANCE

Troubleshooting schedule

Keypad

Possible fault codes on the chain saw keypad.

Keypad	Possible faults	Possible action

Warning indicator ﬂashing.	Chain brake engaged.	Pull back the front hand guard to
		release the chain brake.

	Temperature deviation.	Allow the machine to cool down.

	Overload. Cutting attachment	The cutting attachment is jammed.
	jammed.	Release the cutting attachment.

	The power trigger and the	Release the power trigger and the
	activate button are pressed at	machine is active.
	the same time.

Green activate LED ﬂashing.	Low battery voltage.	Charge the battery.

Warning indicator lit.	Service	Contact your service agent.

Battery

Troubleshooting the battery and/or the battery charger during charging.

LED display	Possible faults	Possible action

Warning indicator ﬂashing.	The battery is discharged.	Charge the battery

	Temperature deviation.	Use the battery in surroundings
		where temperatures are between -
		10 °C and 40 °C.

	Over voltage.	Check that the mains voltage
		corresponds with that stated on the
		rating plate on the machine.

		Remove the battery from the
		battery charger.

Warning indicator lit.	Cell difference too much (1V).	Contact your service agent.

Battery charger

LED display	Possible faults	Possible action

Warning indicator ﬂashing.	Temperature deviation.	Use the battery charger only when
		the surrounding temperature is
		between 5 °C and 40 °C.

Warning indicator lit.		Contact your service agent.

English – 39

Image 39

Contents 436 Li, 536 LiXP KEY to Symbols Symbols on the machineSymbols on the battery and/or on the battery charger Symbols in the operator’s manual Contents Dear Customer IntroductionWhat is what on the chain saw? What is WHAT?General power tool safety warnings General Safety PrecautionsCauses and operator prevention of kickback Battery tool use and careService Chain saw safety warningsBefore using a new chain saw Personal protective equipment Always use common senseChain brake and front hand guard Machine′s safety equipmentAutomatic switch off functionality KeypadGeneral Safety Precautions Battery and battery charger Battery charger safety Cutting equipmentGeneral rules Cutting equipment designed to reduce kickback General information on sharpening cutting teeth Sharpening your chain and adjusting depth gauge settingToo large General advice on adjusting depth gauge settingAdjustment of depth gauge setting Tensioning the chainLiXP 436 LiLubricating cutting equipment Filling with chain oil Checking chain lubricationChain drive sprocket Checking wear on cutting equipment Assembly Fitting the bar and chainWorking with the chain Fitting a spike bumper Battery Handling BatteryBattery charger Disposal of the battery, battery charger and machine Transport and storageLED display Charging status Starting Starting and StoppingStarting and stopping StartingStopping SavE Basic safety rulesWorking Techniques Before useGeneral rules General Basic cutting techniqueNot safely controlled with one hand Handles with both handsFelling direction Tree felling techniqueLog is supported at both ends. There is a high risk Safe distanceDirectional cuts Clearing the trunk and preparing your retreatFelling Training we advise you not to fell trees Your sawFreeing a trapped tree Freeing a tree that has fallen badlyWhat is kickback? How to avoid kickbackCutting the trunk into logs Checking the inertia brake release MaintenanceGeneral Checking the front hand guardBattery connectors Power trigger lockoutLubricating the bar tip sprocket Cooling system Daily maintenance Weekly maintenance Monthly maintenance Maintenance scheduleKeypad Possible faults Possible action Troubleshooting scheduleBattery Battery chargerTechnical data Technical DataGuide bar and saw chain combinations Saw chain ﬁling and ﬁle gauges EC-declaration of conformityApplies to Europe only Page Page 1154476-26