Husqvarna BZ7234D Dampener Mounting, Reverse Detent Adjustment, Motion Control Linkage Adjustment

MAINTENANCE

Dampener Mounting

Dampeners must be free to pivot.

Distance between nuts (5/32” minimum) must be maintained so the dampener can pivot freely, both ends. See illustration.

Reverse Detent Adjustment

Stop engine and remove key.

Pull the motion control lever back to the reverse position and release the lever. When the lever stops it should be in line with the neutral slot, so you can move the lever into neutral slot with out hitting the side of the console frame.

If adjustment is required put the seat in the rear most position on the slide, tilt the seat forward, remove the seat rod from seat frame and fold seat over forward onto the frame.

On the back of the console where the spring is fastened, loosen the 3/8” nut and bolt enough to allow the bolt to slide in the slot. See illustration.

Motion Control Linkage

Adjustment

This adjustment must be made with the rear wheels rotating. Raise the rear of the machine and block it up so the wheels are free to rotate.

CAUTION!

Keep hands, feet and clothing away from rotating tires.

Tilt seat forward and remove the seat rod so the seat may rotate forward onto the frame.

Place a 2 x 4 board between the foot plate and the center of the seat to engage the seat safety switch.

Loosen the nuts (A & B) directly behind each ball joint on linkages (C). See illustration.

Start the engine. The park brake must be engaged and the motion control levers in the neutral slots to start the engine. Run the engine approximately half throttle. Release park brake to allow the wheels to rotate.

Nuts

Dampener

Dampenerpener Mounting

Motion	Reverse Detent
Control
	Adjustment Slot
Lever
	Reverse Detent
	Spring

Reverse Detent Adjustment

		Turn Here to
Motion		Adjust
Control
Lever
A	C	D
		B
Left Hand Threads		Pump Arm

Motion Control Linkage Adjustment

37