Husqvarna Rider 15V2 manual Checking the blades

Page 41

MAINTENANCE

Checking the blades

To achieve the best mowing results it is important that the blades are undamaged and well-sharpened.

Check that the blades’ attachment screws are tight.

IMPORTANT INFORMATION

Replacing or sharpening the blades should be conducted by an authorised service workshop.

The blades should be balanced after sharpening.

Damaged blades should be replaced when hitting obstacles that result in a breakdown. Let the servicing dealer judge whether the blade can be repaired/ground or must be discarded.

IMPORTANT INFORMATION

Combi unit 103 should always have the blades in the relative position shown in the diagrams with an angle of 90° between the blades. Otherwise the blades can go against each other and damage the unit.

90°	90°
	8009-432

Combi 103

8009-288

Combi 112

Cutting unit with side ejection

6017-020

English – 39

Image 41

Contents

Rider Svenska Contents General operation Safe operation practices for ride-on mowersII. Slope operation III. ChildrenTravel and transport on public roads IV. ServiceTowing Intended useDear customer IntroductionTravel and transport on public roads TowingSerial number Good serviceStarting Instruction Explanation of SymbolsGeneral use Safety InstructionsKeep children away from the area to be mowed Proceed as follows Driving on slopesChildren MaintenanceDo not smoke when carrying out maintenance Transport Location of the controls PresentationPresentation Choke lever Throttle controlSpeed limiter Parking brakeLift lever for cutting unit Cutting unitFuelling Lever for adjustment of cutting heightSeat Starting the engine DrivingBefore starting 6017-244 6017-245 Driving the machine Cutting tips Release lever Stopping the engineMaintenance schedule MaintenanceDaily Maintenance interval Hours Before start 100 200Engine hood Removing the machine hoodsFront hood Right-hand fenderPoorly adjusted brakes can result in reduced braking power Checking and adjustment of the steering wiresAdjusting the brake Replacing the fuel filter Checking and adjustment of the throttle wireChecking and adjusting the choke wire Varning Replacing the air filterFitting the wrong spark plug type can damage the engine Check the level of the battery acidChecking of the fuel pump’s air filter Inspecting the safety system Checking the engine’s cooling air intake Main fuseChecking the tyre pressure Observe caution to avoid trapping your hand Fitting the cutting unitRemoving the cutting unit Checking and adjusting the cutting unit’s ground pressure Checking the cutting unit’s parallelism Adjusting the parallelism of the cutting unitBelt change on Combi Replacing the cutting unit belts Belt change on cutting unit with side ejection and Combi Placing in service position Service position for the cutting unit6017-221 6017-222 8009-122 6017-223 Restoring from service position Checking the blades Removal of BioClip plug Combi Replacing the break-pin CombiChecking the engine’s oil level LubricationChanging the oil filter Changing the oilGeneral lubrication Lubricating the belt adjusterChecking the transmission’s oil level Problem Procedure Trouble Shooting ScheduleStorage ServiceWinter storage CoverTechnical Data Work done Service JournalPre-delivery service Work done Date, mileage, stamp, sign Service Journal Service Journal ´z+H-¶5O¨ Page 114 01