Husqvarna Rider 15V2 manual Good service, Serial number

Page 7

INTRODUCTION

Good service

Husqvarna products are sold all over the world and only through servicing dealers. This is to ensure that you, the customer, get the best support and service.

When you need spare parts or advice on service issues, warranty terms, etc., contact:

This Operator’s Manual belongs to machine with serial number:

Engine

Transmission

Serial number

The serial number can be found on the printed plate attached to the front, left-hand side under the seat. Stated on the plate, from the top are:

The type designation of the machine.

The manufacturer’s type number.

The serial number of the machine.

State the type designation and serial number when ordering spare parts.

The engine number is stated at a bar-code decal placed on the left side of the crankcase, in front of the starter. The bar-code states:

The serial number of the engine.

Code.

Please state these when ordering spare parts.

The transmission’s serial number is stated on the barcode decal located on the front of the housing on the left-hand drive axle:

Type designation is stated above the barcode and starts with the letter “K”.

The serial number is stated above the barcode and has the prefix “s/n”.

The manufacturer’s type number is stated under the barcode and has the prefix “p/n”. State the type designation and serial number when ordering spare parts.

English – 5

Image 7 Contents
Rider Svenska Contents III. Children Safe operation practices for ride-on mowersGeneral operation II. Slope operationIntended use IV. ServiceTravel and transport on public roads TowingTowing IntroductionDear customer Travel and transport on public roadsSerial number Good serviceStarting Instruction Explanation of SymbolsGeneral use Safety InstructionsKeep children away from the area to be mowed Proceed as follows Driving on slopesChildren MaintenanceDo not smoke when carrying out maintenance Transport Presentation PresentationLocation of the controls Parking brake Throttle controlChoke lever Speed limiterLift lever for cutting unit Cutting unitSeat Lever for adjustment of cutting heightFuelling Before starting DrivingStarting the engine 6017-244 6017-245 Driving the machine Cutting tips Release lever Stopping the engineHours Before start 100 200 MaintenanceMaintenance schedule Daily Maintenance intervalRight-hand fender Removing the machine hoodsEngine hood Front hoodAdjusting the brake Checking and adjustment of the steering wiresPoorly adjusted brakes can result in reduced braking power Checking and adjusting the choke wire Checking and adjustment of the throttle wireReplacing the fuel filter Varning Replacing the air filterChecking of the fuel pump’s air filter Check the level of the battery acidFitting the wrong spark plug type can damage the engine Inspecting the safety system Checking the tyre pressure Main fuseChecking the engine’s cooling air intake Observe caution to avoid trapping your hand Fitting the cutting unitRemoving the cutting unit Checking and adjusting the cutting unit’s ground pressure Checking the cutting unit’s parallelism Adjusting the parallelism of the cutting unitBelt change on Combi Replacing the cutting unit beltsBelt change on cutting unit with side ejection and Combi Placing in service position Service position for the cutting unit6017-221 6017-222 8009-122 6017-223 Restoring from service position Checking the blades Removal of BioClip plug Combi Replacing the break-pin CombiChecking the engine’s oil level LubricationChanging the oil filter Changing the oilChecking the transmission’s oil level Lubricating the belt adjusterGeneral lubrication Problem Procedure Trouble Shooting ScheduleCover ServiceStorage Winter storageTechnical Data Pre-delivery service Service JournalWork done Work done Date, mileage, stamp, sign Service Journal Service Journal ´z+H-¶5O¨ Page 114 01