Husqvarna 260 ACX manual Movement pattern

Page 13

2. PRESENTATION

The control panel on the top of Automower® is where you manage all the mower settings. The main switch is also located on the control panel. Open the control panel cover by pressing down the STOP button.

When the main switch is turned ON for the first time, a start-up sequence begins which includes: selection of the language, time format, date format and four digit PIN code, plus setting of the time and date, see page 29.

The selected PIN code must then be entered each time the main switch is moved to the ON position. This theft-prevention function is called Time lock (4-1-2)and Automower® has this function activated as a default setting. The function also means that the mower stops mowing after a set number of days and will not continue until the correct PIN code has been entered. The function can be deactivated or changed as required. For more information about Time lock (4-1-2), see page 52.

Automower® can enter a sleep mode to save power. The display on the control panel is then completely dimmed.

The sleep mode is activated 25 minutes after the STOP button has been pressed and then not reset to the operating mode. Automower® is then activated by switching the main switch off and on.

The sleep mode can also be activated in the event of a fault occurring during mowing or charging and which is not rectified within 25 minutes. Automower® is then activated by pressing the STOP button.

Movement pattern

The mower’s movement pattern is irregular and is determined by Automower® itself. A movement pattern is never repeated. This mowing system means the lawn is mown equally without any mowing lines.

If Automower® enters an area where it senses the grass is longer than earlier, it can change the movement pattern. It can then mow in a square pattern to cover the area of longer grass more systematically.

When Automower® mows in a square pattern, this is known as square mode cutting. The mower must have been operational for more than 6 hours in order for Automower® to start square mode cutting.

12 - English

Image 13

Contents Husqvarna Automower Table of Contents Table of Contents Introduction Introduction SafetySymbols on Automower Xxxxxx xxxxx xxxx xxxx xxxxx Symbols in the Operator’s ManualImportant Information Xxxxxx xxxxx xxxx xxxx xxxxx Use Safety instructionsTransport MaintenancePresentation Numbers in the picture correspond to Automower, what’s what?Capacity Function of AutomowerMowing technique Working method Movement pattern Search method Search method 2 Follow boundary wireSearch method 1 Irregular More than one Automower in a garden Search method 3 Follow guide wireOne Automower in several gardens Carry out the installation in the following steps InstallationPreparations Ideal position of the charging station Installation of the charging stationImportant Information Installation and connecting the charging station Installation of the boundary wire Charging the batteryDo not tread or walk on the charging station plate Best position for the boundary wire Boundaries for the working area Boundaries within the working area Passages when searching for the charging station Passages when mowingSecondary areas Slopes Laying out the boundary wire Joining the boundary wire Laying the boundary wire in towards the charging stationConnecting the boundary wire Installation Linking Automower to the charging station Checking the installationNeed of a guide wire Installation of the guide wirePlacement and connection of the guide wire Maximum 135º Use Charging a discharged batteryUse of SMS function Using the timerStarting Automower Stopping AutomowerRestart Switching off AutomowerRestart within 20 seconds Restart after more than 20 secondsAdjusting the cutting height Control panel Shortcuts Select Main switchNumbers Main menu Menu functionsBrowse between menus Number seriesAutomower main menu Installation SettingsTimer CommandsYES Reset all timersStart time 1 Stop time 1 Start time 2 Stop time 2 Mon Tue Wed Thu Fri Sat Sun Run allReversing distance InstallationStart angle 1 End angle 1Gardens where the front and back are joined by a To follow the boundary wire or a guide wire awayPassage where the charging station cannot be When this function is activated Automower willDistance DirectionProportion Follow loopCorridor width Test Test OUT Settings Time lock PIN codeSMS AlarmSet date Set timeTime format Date formatSound Significance SoundsGarden example Proposed installation and settingsExit angles Exit angles 250 Corridor width Garden Example Battery MaintenanceWinter storage ServiceAutomower Charging stationAfter winter storage CleaningUnderframe and blade disc Replacing the blades Do not use running water when cleaningChassis WheelsMaintenance Fault messages Trouble shootingTrouble Shooting Fault symptom Environmental Information Technical dataData Automower 260 ACX EU Declaration of Conformity only applies to Europe EU declaration of conformity115 13

Related manuals

Manual 76 pages 48.62 Kb