Husqvarna 260 ACX manual Trouble shooting, Fault messages

Page 67

9.TROUBLE SHOOTING

9.Trouble shooting

9.1 Fault messages

A number of fault messages are listed below that can be shown on Husqvarna Automower®. If the same fault occurs frequently: contact your dealer.

Fault message

Cause

Action

 

 

 

 

 

 

Left wheel motor

Grass or other object has wrapped

Check the drive wheel and remove

blocked

around the drive wheel.

the grass or other object.

 

 

 

Right wheel motor

Grass or other object has wrapped

Check the drive wheel and remove

blocked

around the drive wheel.

the grass or other object.

 

 

 

Blade disc blocked

Grass or other object has wrapped

Check the blade disc and remove the

 

around the blade disc.

grass or other object.

 

 

 

No loop signal

The transformer is not connected to

Check the wall socket connection and

 

the mains supply or its miniature

whether the miniature circuit-breaker

 

circuit-breaker has tripped.

has tripped.

 

 

Reset the miniature circuit-breaker by

 

 

removing the transformer’s power

 

 

cord from the wall socket, wait

 

 

10 seconds and then reconnect the

 

 

power cord in the wall socket again.

 

 

 

 

Boundary wire broken.

Check the signal given by the LED on

 

 

the charging station. If it flashes the

 

 

loop is damaged. Repair the broken

 

 

cable using an original waterproof

 

 

coupler.

 

 

 

 

The connection between Automower®

Place Automower® in the charging

 

and the charging station has been

station and change the PIN-code via

 

lost.

Settings - Security - PIN code

 

 

(shortcut 4-1-1). You can use the

 

 

same PIN code as earlier.

 

 

 

 

This may be due to the boundary wire

Check that the boundary wire has

 

being routed in the wrong direction

been routed correctly.

 

around an ”island”, which blanks out

 

 

the signal.

 

 

 

 

 

If this occurs in isolated areas it may

Try moving the boundary wire.

 

be due to interference from metallic

 

 

objects (perimeter fence,

 

 

reinforcement bar) or buried cables in

 

 

the vicinity.

 

 

 

 

Trapped

Automower® has got caught in

Free Automower® and rectify the

 

something.

reason for it getting trapped.

 

 

 

66 - English

Page 66 Page 68
Image 67
Page 66 Page 68
Contents Husqvarna Automower Table of Contents Table of Contents Introduction Introduction SafetySymbols on Automower Xxxxxx xxxxx xxxx xxxx xxxxx Symbols in the Operator’s ManualImportant Information Xxxxxx xxxxx xxxx xxxx xxxxx Use Safety instructionsTransport MaintenancePresentation Numbers in the picture correspond to Automower, what’s what?Capacity Function of AutomowerMowing technique Working method Movement pattern Search method Search method 2 Follow boundary wireSearch method 1 Irregular More than one Automower in a garden Search method 3 Follow guide wireOne Automower in several gardens Carry out the installation in the following steps InstallationPreparations Ideal position of the charging station Installation of the charging stationImportant Information Installation and connecting the charging station Installation of the boundary wire Charging the batteryDo not tread or walk on the charging station plate Best position for the boundary wire Boundaries for the working area Boundaries within the working area Passages when searching for the charging station Passages when mowingSecondary areas Slopes Laying out the boundary wire Joining the boundary wire Laying the boundary wire in towards the charging stationConnecting the boundary wire Installation Linking Automower to the charging station Checking the installationNeed of a guide wire Installation of the guide wirePlacement and connection of the guide wire Maximum 135º Use Charging a discharged batteryStopping Automower Using the timerUse of SMS function Starting AutomowerRestart after more than 20 seconds Switching off AutomowerRestart Restart within 20 secondsAdjusting the cutting height Control panel Shortcuts Select Main switchNumbers Number series Menu functionsMain menu Browse between menusAutomower main menu Installation SettingsTimer CommandsMon Tue Wed Thu Fri Sat Sun Run all Reset all timersYES Start time 1 Stop time 1 Start time 2 Stop time 2End angle 1 InstallationReversing distance Start angle 1When this function is activated Automower will To follow the boundary wire or a guide wire awayGardens where the front and back are joined by a Passage where the charging station cannot beFollow loop DirectionDistance ProportionCorridor width Test Test OUT Settings Time lock PIN codeSMS AlarmDate format Set timeSet date Time formatSound Significance SoundsGarden example Proposed installation and settingsExit angles Exit angles 250 Corridor width Garden Example Battery MaintenanceCharging station ServiceWinter storage AutomowerAfter winter storage CleaningUnderframe and blade disc Wheels Do not use running water when cleaningReplacing the blades ChassisMaintenance Fault messages Trouble shootingTrouble Shooting Fault symptom Environmental Information Technical dataData Automower 260 ACX EU Declaration of Conformity only applies to Europe EU declaration of conformity115 13
Related manuals
Manual 76 pages 48.62 Kb

260 ACX specifications

The Husqvarna 260 ACX is a versatile and powerful chainsaw designed for both professionals and serious hobbyists alike. Renowned for its reliability and performance, the 260 ACX comes packed with features that cater to a wide range of cutting tasks, from tree felling to limb trimming and firewood processing.

One of the standout characteristics of the Husqvarna 260 ACX is its robust engine. It is equipped with a 50.2cc X-Torq engine that delivers a high power-to-weight ratio, ensuring efficient and powerful performance with reduced fuel consumption and lower emissions. This makes it not only eco-friendly but also cost-effective for prolonged use.

The chainsaw employs the innovative AutoTune technology, which automatically adjusts the engine's settings for optimal performance. This feature eliminates the need for frequent manual adjustments, allowing the user to maintain productivity without interruptions. The 260 ACX also comes with an Air Injection system, which helps to reduce the amount of dust and debris entering the air filter, extending its lifespan and maintaining engine efficiency.

Comfort during use is a priority in the design of the Husqvarna 260 ACX. It features an ergonomic handle with an anti-vibration system that minimizes fatigue, allowing users to work longer without discomfort. Additionally, the chainsaw has an easy-to-access chain tensioning system that simplifies the process of adjusting the chain, enhancing user convenience.

Safety is critical in chainsaw operation, and the Husqvarna 260 ACX is designed with several safety features. It includes a chain brake that activates in case of kickback, reducing the risk of injury. The chainsaw's low kickback bar and chain also contribute to safer operation, making it suitable for users of varying skill levels.

Furthermore, the 260 ACX features a durable build, incorporating high-quality materials that ensure longevity, even under demanding conditions. Its lightweight design, combined with a well-balanced construction, facilitates easy maneuverability, making it an ideal choice for both ground-level and overhead cutting tasks.

In summary, the Husqvarna 260 ACX is a reliable chainsaw that blends power, efficiency, and user comfort. With its advanced technologies, focus on safety, and versatile capabilities, it stands out as an excellent tool for anyone looking to tackle tough cutting jobs with ease and confidence.
Top Page Image Contents