Husqvarna 260 ACX manual Fault symptom

Page 69

9. TROUBLE SHOOTING

9.2 Fault symptom

If your Automower® does not work correctly, follow the trouble shooting guide below. If the fault persists; contact your dealer.

Symptom

Cause

Action

 

 

 

 

 

 

Uneven mowing

Automower® works too few hours per

Increase the mowing time, see 6.4

results

day.

Timer (2) on page 43.

 

 

 

 

Working area too large.

Try limiting the working area or

 

 

extending the working time, see 6.4

 

 

Timer (2) on page 43.

 

 

 

 

Dull blades.

Replace all the blades and screws so

 

 

that the rotating parts are balanced.

 

 

 

 

Long grass in relation to the set cutting

Increase the cutting height and then

 

height.

successively lower.

 

 

 

 

The mower seems to work more at the

Change the Garden shape (3-3)

 

top of a slope than at the bottom.

setting to Open.

 

 

 

 

Accumulation of grass by the blade

Check that the skid plate and blade

 

disc or around the motor shaft.

disc rotate easily. If not, the skid plate

 

 

and perhaps the blade disc must be

 

 

removed and the grass and foreign

 

 

objects removed. See 8.5 Cleaning on

 

 

page 63.

 

 

 

Automower® runs at

The clock on Automower® needs to be

Set the clock, see Time and date (4-3)

the wrong time

set.

on page 54.

 

 

 

 

The start and stop times for mowing

Adjust the start and stop time settings

 

are incorrect.

for mowing, see 6.4 Timer (2) on

 

 

page 43.

 

 

 

Automower® vibrates

Unbalanced blade disc or damaged

Inspect the blades and screws and

 

blades.

replace them if necessary.

 

 

 

Automower® runs, but

Automower® is looking for the charging

No action. The blade disc does not

the blade disc does

station.

rotate when the mower is searching for

not rotate

 

the charging station.

 

 

 

The mower mows for

Grass or a foreign object is blocking

Dismantle and clean the skid plate and

shorter periods than

the blade disc or skid plate.

blade disc.

usual between

 

 

charges

 

 

 

 

 

Both the mowing and

This behaviour is normal in high

No action.

charging times are

temperatures (gradually increasing

 

shorter than usual

above 25 °C).

 

 

 

 

Automower® starts

 

Change corridor width and/or

mowing directly

 

reversing distance.

outside of the

 

 

charging station

 

 

instead of following

 

 

the loop out

 

 

 

 

 

68 - English

Page 68 Page 70
Image 69
Page 68 Page 70
Contents Husqvarna Automower Table of Contents Table of Contents Introduction Introduction SafetySymbols on Automower Symbols in the Operator’s Manual Xxxxxx xxxxx xxxx xxxx xxxxxImportant Information Xxxxxx xxxxx xxxx xxxx xxxxx Use Safety instructionsTransport MaintenancePresentation Numbers in the picture correspond to Automower, what’s what?Function of Automower CapacityMowing technique Working method Movement pattern Search method 2 Follow boundary wire Search methodSearch method 1 Irregular Search method 3 Follow guide wire More than one Automower in a gardenOne Automower in several gardens Installation Carry out the installation in the following stepsPreparations Ideal position of the charging station Installation of the charging stationImportant Information Installation and connecting the charging station Charging the battery Installation of the boundary wireDo not tread or walk on the charging station plate Best position for the boundary wire Boundaries for the working area Boundaries within the working area Passages when mowing Passages when searching for the charging stationSecondary areas Slopes Laying out the boundary wire Joining the boundary wire Laying the boundary wire in towards the charging stationConnecting the boundary wire Installation Linking Automower to the charging station Checking the installationNeed of a guide wire Installation of the guide wirePlacement and connection of the guide wire Maximum 135º Use Charging a discharged batteryUse of SMS function Using the timerStarting Automower Stopping AutomowerRestart Switching off AutomowerRestart within 20 seconds Restart after more than 20 secondsAdjusting the cutting height Control panel Shortcuts Main switch SelectNumbers Main menu Menu functionsBrowse between menus Number seriesAutomower main menu Installation SettingsTimer CommandsYES Reset all timersStart time 1 Stop time 1 Start time 2 Stop time 2 Mon Tue Wed Thu Fri Sat Sun Run allReversing distance InstallationStart angle 1 End angle 1Gardens where the front and back are joined by a To follow the boundary wire or a guide wire awayPassage where the charging station cannot be When this function is activated Automower willDistance DirectionProportion Follow loopCorridor width Test Test OUT Settings Time lock PIN codeSMS AlarmSet date Set timeTime format Date formatSound Significance SoundsGarden example Proposed installation and settingsExit angles Exit angles 250 Corridor width Garden Example Battery MaintenanceWinter storage ServiceAutomower Charging stationCleaning After winter storageUnderframe and blade disc Replacing the blades Do not use running water when cleaningChassis WheelsMaintenance Fault messages Trouble shootingTrouble Shooting Fault symptom Technical data Environmental InformationData Automower 260 ACX EU Declaration of Conformity only applies to Europe EU declaration of conformity115 13
Related manuals
Manual 76 pages 48.62 Kb

260 ACX specifications

The Husqvarna 260 ACX is a versatile and powerful chainsaw designed for both professionals and serious hobbyists alike. Renowned for its reliability and performance, the 260 ACX comes packed with features that cater to a wide range of cutting tasks, from tree felling to limb trimming and firewood processing.

One of the standout characteristics of the Husqvarna 260 ACX is its robust engine. It is equipped with a 50.2cc X-Torq engine that delivers a high power-to-weight ratio, ensuring efficient and powerful performance with reduced fuel consumption and lower emissions. This makes it not only eco-friendly but also cost-effective for prolonged use.

The chainsaw employs the innovative AutoTune technology, which automatically adjusts the engine's settings for optimal performance. This feature eliminates the need for frequent manual adjustments, allowing the user to maintain productivity without interruptions. The 260 ACX also comes with an Air Injection system, which helps to reduce the amount of dust and debris entering the air filter, extending its lifespan and maintaining engine efficiency.

Comfort during use is a priority in the design of the Husqvarna 260 ACX. It features an ergonomic handle with an anti-vibration system that minimizes fatigue, allowing users to work longer without discomfort. Additionally, the chainsaw has an easy-to-access chain tensioning system that simplifies the process of adjusting the chain, enhancing user convenience.

Safety is critical in chainsaw operation, and the Husqvarna 260 ACX is designed with several safety features. It includes a chain brake that activates in case of kickback, reducing the risk of injury. The chainsaw's low kickback bar and chain also contribute to safer operation, making it suitable for users of varying skill levels.

Furthermore, the 260 ACX features a durable build, incorporating high-quality materials that ensure longevity, even under demanding conditions. Its lightweight design, combined with a well-balanced construction, facilitates easy maneuverability, making it an ideal choice for both ground-level and overhead cutting tasks.

In summary, the Husqvarna 260 ACX is a reliable chainsaw that blends power, efficiency, and user comfort. With its advanced technologies, focus on safety, and versatile capabilities, it stands out as an excellent tool for anyone looking to tackle tough cutting jobs with ease and confidence.
Top Page Image Contents