Husqvarna 240440 Service and Adjustments, To Remove Mower See Fig, To Install Mower See Figs

Page 19

SERVICE AND ADJUSTMENTS

WARNING: TO AVOID SERIOUS iNJURY, BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS: Depress brake pedal fully and set parking brake.

o

o Place attachment clutch in "DISENGAGED" position.

oTurn ignition key to "STOP" and remove key.

=Make sure the blades and all moving parts have completely stopped.

=Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug.

TO REMOVE MOWER (See Fig. 23)

•Place attachment clutch in "DISENGAGED" position.

•Lower attachment lift lever to its lowest position.

•Disengage belt tension rod (K) from lock bracket (L).

loaded. Have a tight grip on rodand CAUTION: Belt tension rod is spring release slowly.

•Remove mower belt from electric clutch pulley (M).

•Disconnect front link (E) from mower - remove retainer spring and washer.

•Goto eitherside ofmower anddisconnect mowersuspen- sion arm (A) from chassis and rear lift link (0) from rear mower bracket (D)- remove retainersprings andwashers.

•Go to other side of mower and disconnect the suspen- sion arm and rear lift link.

&CAUTION:After rear lift linksare discon= nected, the attachment lift lever will be spring loaded. Have aright grip on lift le- ver when changing position of the lever.

From right side of mower, disconnect anti-sway bar (S) from right rear mower bracket (D) - remove retainer

spring and washer and pull mower toward you until the bar falls from the hole in bracket.

Turn tractor steering wheel to the left as far as itwill go. Slide mower out from under right side of tractor.

TO INSTALL MOWER (See Figs. 23 - 35)

1.SET PARKING BRAKE LEVER AND LOWER AT=

TACHMENT LIFT LEVER (See Fig. 24 and 25)

•Depress clutch/brake pedal all the way down and hold.

•Pull parking brake lever up and hold, release pressure from clutch/brake pedal, then release parking brake lever. Pedal should remain in brake position. Ensure parking brake will hold tractor secure.

_-r'_PARKING BRAKE

Fig. 24

CAUTION: Lift lever is spring loaded. Have a1

tight grip on lift lever, lower it slowly and en= ga ;je in lowest position. Lift lever is located

on left side of fender.

J

LIFT

Fig. 25

A. MOWER SIDE SUSPENSION

ARMS

B. RETAINER SPRING

C.REAR LIFT LINK(S)

D.RIGHT SIDE REAR MOWER BRAC KET

E.FRONT LIFT LINK ASSEMBLY

F.FRONT SUSPENSION BRACKET

H. FRONT MOWER BRACKET

I, LEFT SIDE REAR MOWER

BRACKET

K. BELT TENSION ROD

L. LOCKING BRACKET

M. ENGINE CLUTCH PULLEY

Q. DEFLECTOR SHIELD

S, ANTI-SWAY BAR

W. FRONT GAUGE WHEEL

Fig. 23

19

Page 18 Page 20
Image 19
Page 18 Page 20
Contents 532 44 Defects or other reproductive harm. Wash hands Safe Operation Practices for Ride=On MowersGeneral Operation II. Slope OperationIV. Towing ServiceRules Safe Operation PracticesContents Steering Wheel Unassembled PartsBefore Removing Tractor from Skid AssemblyTools Required for Assembly To Remove Tractor from CartonCheck for Proper Position of Belts To Adjust Seat See FigCheck Tire Pressure Check Deck LevelnessSystem ROS OperationKnow Your Tractor To USE Throttle Control D See Fig HOW to USE Your TractorTo SET Parking Brake See Fig Stopping See FigTo USE Cruise Control J See Fig To Adjust Mower Cutting HeightTo Adjust Gauge Wheels See Fig To Move Forward and BackwardTo Transport See Figs To Stop Mower BladesReverse Operation System ROS To Operate on HillsADD Gasoline Service REMINDER/HOUR MeterBefore Starting the Engine Check Engine OiL LevelPurge Transmission Mowing TipsBefore Each USE MaintenanceGeneral Recommendations ScheduleBlade Removal See Fig BatteryTractor Blade CareTransaxle Pump Fluid Clean AIR Screen=BELTS Transaxle CoolingDeck Washout Port See Fig CleaningMuffler IN=LINE Fuel Filter See FigTachment Lift Lever See Service and AdjustmentsTo Install Mower See Figs To Remove Mower See Fig= Turn Steering Wheel Left and Position Mower See Fig AdjustmentsANTI=SWAY Attach Rear Lift Links C See Fig Attach Mower Side Suspension Arms a to Chassis See FigYour hands with gloves and/or wrap To Level MowerTo Replace Motion Drive Belt To Replace Mower Blade Drive BeltFront Wheel TOE-IN/CAMBER To Adjust Steering Wheel AlignmentTo Check Brake To Remove Wheel See FigTransmission EngineSee Fig Engine OiL TractorOther Fuel SystemTroubleshooting Charge Battery Will notPoor cut = uneven Working If soTractor - Model Number YTH2348 SchematicElectrical NO. NO.DESCRIPTION KEY PartTractor - Model Number YTH2348 Chassis KEY Chassis Tractor - Model NumberTractor - Model Number YTH2348 Drive Idler Flat DriveEngine DESCRiPTiON Tractor - Model Number YTH2348 EngineI68 Steering AssemblyDescription Seat AssemblyTractor - Model Number YTH2348 Mower Deck KEY Part Description Mower DeckMower Lift NO. NO.DESCRIPTION Tractor - Model Number YTH2348 DecalsWheels and Tires NO. NO.DESCRiPTiONTufftorq Transaxle Model Number K46BT Model K46BTTufftorq Transaxle Model Number K46BT 10t LO5@ Tractor - Model Number YTH2348I33 Kit Magneto Side 133 699724 Pump 524 691032 Seal-Dipstick Tube 1022 690971 Consumer Wheeled Products Limited Warranty HOW to Obtain Service 11111111111111111111 Consumer Wheeled Warranty ChartAll other Pressure Washers 6027PW, 9032PW, 1340PW Only Ride UP and Down HILL, not Across Hill Degrees MAX Suggested Guide for Sighting Slopes for Safe OperationHusqvarna
Top Page Image Contents