Husqvarna 240440 owner manual Engine, Transmission, See Fig

Page 25

SERVICE AND

REPLACING BATTERY (See Fig. 44)

nals by allowing a wrench or any other

_ objectWARNING:to contactDo notshortboth terminalsbatterytermi=the same time. Before connecting battery, remove metal bracelets, wristwatch

bands, rings, etc. Positive terminal

must be connected first to prevent sparking from accidental grounding.

•Lift hood to raised position.

•Remove terminal cover.

•Disconnect BLACK battery cable then RED battery cable and carefully remove battery from tractor.

•Install new battery with terminals in same position as old battery.

•Reinstall terminal cover.

•First connect RED battery cable to positive (+) battery terminal with bolt and nut as shown. Tighten securely.

•Connect BLACKgrounding cable to negative (-) battery terminal with remaining bolt and nut. Tighten securely

•Close hood.

NEGATIVE (BLACK)

TERMINAL

ADJUSTMENTS

TO REMOVE HOOD AND GRILL ASSEMBLY

(See Fig. 45)

•Raise hood.

•Unsnap headlight wire connector.

•Stand in front of tractor. Grasp hood at sides, tilt toward engine and lift off of tractor.

•To replace, reverse above procedure.

HOOD

HEADLIGHT

WIRE

CONNECTOR

 

 

Fig. 45

 

 

ENGINE

 

 

 

POSiTiVE

TO ADJUST THROTTLE

CONTROL

CABLE

(RED)

The throttle control

has been

preset at the

factory and

CABLE

 

adjustment should not be necessary. If adjustment is nec-

 

essary, see engine

manual.

 

 

Fig. 44

TO REPLACE HEADLIGHT BULB

•Raise hood.

•Pull bulb holder out of the hole in the backside of the grill.

•Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill.

•Close hood.

INTERLOCKS AND RELAYS

Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting.

•Check wiring. See electrical wiring diagram in the Repair Parts section.

TO REPLACE FUSE

Replace with 20 amp automotive-type plug-in fuse. The fuse holder is located behind the dash.

TO ADJUST CHOKE CONTROL

The choke control has been preset at the factory and adjust- ment should not be necessary. If adjustment is necessary, see engne manual.

TO ADJUST CARBURETOR

Your carburetor is not adjustable. If your engine does not operate properly due to suspected carburetor problems, take your tractor to an authorized service center for repair and/or adjustment.

TRANSMISSION

REMOVAL/REPLACEMENT

Should your transmission require removal for service or replacement, it should be purged after reinstallation and before operating the tractor. See"PU RGETRANSMISSION" in the Operation section of this manual.

25

Page 24 Page 26
Image 25
Page 24 Page 26
Contents 532 44 General Operation Safe Operation Practices for Ride=On MowersII. Slope Operation Defects or other reproductive harm. Wash handsRules ServiceSafe Operation Practices IV. TowingContents Steering Wheel Unassembled PartsTools Required for Assembly AssemblyTo Remove Tractor from Carton Before Removing Tractor from SkidCheck Tire Pressure To Adjust Seat See FigCheck Deck Levelness Check for Proper Position of BeltsSystem ROS OperationKnow Your Tractor To SET Parking Brake See Fig HOW to USE Your TractorStopping See Fig To USE Throttle Control D See FigTo Adjust Gauge Wheels See Fig To Adjust Mower Cutting HeightTo Move Forward and Backward To USE Cruise Control J See FigReverse Operation System ROS To Stop Mower BladesTo Operate on Hills To Transport See FigsBefore Starting the Engine Service REMINDER/HOUR MeterCheck Engine OiL Level ADD GasolinePurge Transmission Mowing TipsGeneral Recommendations MaintenanceSchedule Before Each USETractor BatteryBlade Care Blade Removal See Fig=BELTS Clean AIR ScreenTransaxle Cooling Transaxle Pump FluidMuffler CleaningIN=LINE Fuel Filter See Fig Deck Washout Port See FigTo Install Mower See Figs Service and AdjustmentsTo Remove Mower See Fig Tachment Lift Lever See= Turn Steering Wheel Left and Position Mower See Fig AdjustmentsANTI=SWAY Attach Rear Lift Links C See Fig Attach Mower Side Suspension Arms a to Chassis See FigYour hands with gloves and/or wrap To Level MowerTo Replace Motion Drive Belt To Replace Mower Blade Drive BeltTo Check Brake To Adjust Steering Wheel AlignmentTo Remove Wheel See Fig Front Wheel TOE-IN/CAMBERTransmission EngineSee Fig Other TractorFuel System Engine OiLTroubleshooting Poor cut = uneven Battery Will notWorking If so ChargeTractor - Model Number YTH2348 SchematicElectrical NO. NO.DESCRIPTION KEY PartTractor - Model Number YTH2348 Chassis KEY Chassis Tractor - Model NumberTractor - Model Number YTH2348 Drive Idler Flat DriveEngine DESCRiPTiON Tractor - Model Number YTH2348 EngineI68 Steering AssemblyDescription Seat AssemblyTractor - Model Number YTH2348 Mower Deck KEY Part Description Mower DeckMower Lift Wheels and Tires Tractor - Model Number YTH2348 DecalsNO. NO.DESCRiPTiON NO. NO.DESCRIPTIONTufftorq Transaxle Model Number K46BT Model K46BTTufftorq Transaxle Model Number K46BT 10t LO5@ Tractor - Model Number YTH2348I33 Kit Magneto Side 133 699724 Pump 524 691032 Seal-Dipstick Tube 1022 690971 Consumer Wheeled Products Limited Warranty HOW to Obtain Service 11111111111111111111 Consumer Wheeled Warranty ChartAll other Pressure Washers 6027PW, 9032PW, 1340PW Only Ride UP and Down HILL, not Across Hill Degrees MAX Suggested Guide for Sighting Slopes for Safe OperationHusqvarna
Top Page Image Contents