Husqvarna 240440 Adjustments, = Turn Steering Wheel Left and Position Mower See Fig, Anti=Sway

SERVICE AND

=ASSEMBLE FRONT GAUGE WHEEL (W) TO FRONT OF MOWER (See Fig. 26)

H.FRONT MOWER BRACKET

W. FRONT GAUGE

WHEEL

X. SHOULDER

BOLT

Y. 1=1/40.D.

WASHER

Z. 3/8=18 LOCKNUT

Fig. 26

=TURN STEERING WHEEL LEFT AND POSITION MOWER (See Fig. 27)

Turn steering wheel to the left as far as it will go and position mower on right side of tractor with deflector shield (Q) to the right.

FRONT

TRANSAXLE

Q. DEFLECTOR

SHIELD

ADJUSTMENTS

5= INSTALL ANTI=SWAY BAR (S) (IF EQUIPPED) (See Fig. 29 - 31)

l	ANTI=SWAY	BAR (S)
	_TOWARDS	TOWARDS'_
	TRANSAXLE	MOWER DECK_r_
	90 ° END	iNTEGRATED WASHER END

Fig. 29

•From right side of mower, first insert90 °end of anti-sway bar (S) into hole in transaxle bracket (T), located near left rear tire in front of transaxle.

NOTE: Flashlight may be helpful.

ANTI-SWAY BAR	TRANSAXLE
(s)	BRACKET	(T)
	LOCATED
	BETWEEN	REAR
	TIRES

Fig. 27

4.SLIDE MOWER UNDER TRACTOR (See Fig. 28) Bring belt forward and check belt for proper routing in all mower pulley grooves.

NOTE: Be sure mower side suspension arms (A) are point- ing forward before sliding mower under tractor.

•Slide mower under tractor until it is centered under tractor.

A. MOWER SiDE

SUSPENSION

ARMS

Q. DEFLECTOR

SHIELD

Fig. 28

S. ANTI-SWAY BAR

T. TRANSAXLE BRACKET

Fig. 30

NOTE: Depending on model, bracket (T) may be differ- ent than shown but hole for anti-sway bar will be in same position/location.

•Pivot the integrated washer end of anti-sway bar (S) towards mower deck bracket on right side of mower. Insert integrated washer end of bar into hole in rear mower bracket (D). Move mower as needed to insert integrated washer end of bar into rear mower bracket (D).

•Secure with small washer and small retainer spring as shown.

("	-	C----
6::		/

h		ff	9 ¢@#/ D.R,GHTS,DE
_} _-_		.,L.	_		REAR MOWER
II;	/	f'_ (.2)	_	S.	BRACKET
_.:	_	L.L)	_		ANTI-SWAY BAR
F	_		_ b-C-_b _ -	T.	TRANSAXLE
	__.)--	-	F		BRACKET

Fig. 31

2O