Husqvarna 240440 owner manual Attach Mower Side Suspension Arms a to Chassis See Fig

Page 21

SERVICE AND

6.ATTACH MOWER SIDE SUSPENSION ARMS (A) TO CHASSIS (See Fig. 32)

•Position front hole in side suspension arm (A) over pin on outside of tractor chassis and secure with large washer and large retainer spring (B).

•Repeat on opposite side of tractor.

,?":_4 > j/

/

/

/

/

/

A. MOWER SIDE SUSPENSION ARMS

B. RETAINER SPRING

D. RIGHT SIDE REAR MOWER BRACKET

Fig. 32

7. ATTACH REAR LIFT LINKS (C) (See Fig. 33)

•Insert rod end of rear lift link (C) into hole (U) in tractor lift shaft suspension arm and pivot link down to mower.

•Lift rear corner of mower and position slot in link as- sembly over pin on rear mower bracket (D) and secure with large washer and large retainer spring.

•Repeat on opposite side of tractor.

C.REAR LIFT LINK(S)

D.RIGHT SIDE REAR MOWER BRACKET

U.HOLE

Fig. 33

8 ATTACH FRONT LINK (E) (See Fig. 34)

•Turn steering wheel to position wheels straight forward.

•From front of tractor, insert rod end of front link (E) through front hole in tractor front suspension bracket (F).

•Move to left side of mower and and insert large retainer spring (G) through hole in front link (E) behind front suspension bracket (F).

ADJUSTMENTS

•Insert other end of link (E) into hole in front mower bracket (H) and secure with washer and small retainer spring (J).

NOTE: Requires deck lifting.

FRONT LINK

E.FRONT LIFT LINK ASSEMBLY

F.FRONT SUSPENSION BRACKET

G.LARGE RETAINER SPRING

H.FRONT MOWER BRACKET J. SMALL RETAINER SPRING

M.ENGINE CLUTCH PULLEY

Fig. 34

9INSTALL BELT ON ENGINE CLUTCH PULLEY (M) (See Fig. 23 & 35)

•Disengage belt tension rod (K) from locking bracket (L).

•Install belt onto engine clutch pulley (M).

M.ENGINE

CLUTCH PULLEY

Fig. 35

IMPORTANT: Check belt for proper routing in all mower pulley grooves and under mandrel covers.

•Engage belt tension rod (K) on locking bracket (L).

iCAUTION: Belt tension rod is spring loaded, i Have a tight grip on rod and engage slowly.

•Raise attachment lift lever to highest position.

•If necessary, adjust gauge wheels before operat-

ing mower as shown in the Operation section of this manual.

21

Image 21

Contents 532 44 General Operation Safe Operation Practices for Ride=On MowersII. Slope Operation Defects or other reproductive harm. Wash handsRules ServiceSafe Operation Practices IV. TowingContents Steering Wheel Unassembled PartsTools Required for Assembly AssemblyTo Remove Tractor from Carton Before Removing Tractor from SkidCheck Tire Pressure To Adjust Seat See FigCheck Deck Levelness Check for Proper Position of BeltsSystem ROS OperationKnow Your Tractor To SET Parking Brake See Fig HOW to USE Your TractorStopping See Fig To USE Throttle Control D See FigTo Adjust Gauge Wheels See Fig To Adjust Mower Cutting HeightTo Move Forward and Backward To USE Cruise Control J See FigReverse Operation System ROS To Stop Mower BladesTo Operate on Hills To Transport See FigsBefore Starting the Engine Service REMINDER/HOUR MeterCheck Engine OiL Level ADD GasolinePurge Transmission Mowing TipsGeneral Recommendations MaintenanceSchedule Before Each USETractor BatteryBlade Care Blade Removal See Fig=BELTS Clean AIR ScreenTransaxle Cooling Transaxle Pump Fluid Muffler Cleaning IN=LINE Fuel Filter See Fig Deck Washout Port See FigTo Install Mower See Figs Service and AdjustmentsTo Remove Mower See Fig Tachment Lift Lever SeeAdjustments = Turn Steering Wheel Left and Position Mower See FigANTI=SWAY Attach Rear Lift Links C See Fig Attach Mower Side Suspension Arms a to Chassis See FigYour hands with gloves and/or wrap To Level MowerTo Replace Motion Drive Belt To Replace Mower Blade Drive BeltTo Check Brake To Adjust Steering Wheel AlignmentTo Remove Wheel See Fig Front Wheel TOE-IN/CAMBEREngine TransmissionSee Fig Other TractorFuel System Engine OiLTroubleshooting Poor cut = uneven Battery Will notWorking If so ChargeTractor - Model Number YTH2348 SchematicElectrical NO. NO.DESCRIPTION KEY PartTractor - Model Number YTH2348 Chassis KEY Chassis Tractor - Model NumberTractor - Model Number YTH2348 Drive Idler Flat DriveEngine DESCRiPTiON Tractor - Model Number YTH2348 EngineI68 Steering AssemblyDescription Seat AssemblyTractor - Model Number YTH2348 Mower Deck KEY Part Description Mower DeckMower Lift Wheels and Tires Tractor - Model Number YTH2348 DecalsNO. NO.DESCRiPTiON NO. NO.DESCRIPTIONTufftorq Transaxle Model Number K46BT Model K46BTTufftorq Transaxle Model Number K46BT 10t LO5@ Tractor - Model Number YTH2348I33 Kit Magneto Side 133 699724 Pump 524 691032 Seal-Dipstick Tube 1022 690971 Consumer Wheeled Products Limited Warranty HOW to Obtain Service 11111111111111111111 Consumer Wheeled Warranty ChartAll other Pressure Washers 6027PW, 9032PW, 1340PW Only Ride UP and Down HILL, not Across Hill Degrees MAX Suggested Guide for Sighting Slopes for Safe OperationHusqvarna