Samsung SCC-C4207P, SCC-C4307P Power LED, RS485 terminal, POWER IN terminal, VIDEO OUT terminal, ZOOM/ FOCUS REMOTE terminals, DAY/NIGHT External Signal Input & Alarm Signal Output

✔In Setup Menu Mode

- UP/ DOWN buttons: Use to move the cursor up or down.

- LEFT/ RIGHT buttons: Use to move the cursor left or right, or to sequentially view the values that can be assigned to a parameter.

- ENTER button: Use to select a Sub Menu item, and to accept the current value.

ZOOM/ FOCUS REMOTE terminals

This port is used for ZOOM/FOCUS, MENU CONTROL, HOME RETURN, and AF by using an external controller. Depending on the input condition, 4 modes, A, B, C, and D are available. (SPECIAL - CTRL TYPE)

(Operation Voltage Range : +3V~+13V, -3V~-13V)

1) When the voltage is supplied to either ZOOM or FOCUS port,

	Function	TELE(Up)	WIDE(Down)	NEAR(Left)	FAR(Right)
Code	❖ 1	ZOOM Port		FOCUS Port
	A	-6V	+6V	-6V	+6V
	B	-6V	+6V	+6V	-6V
	C	+6V	-6V	-6V	+6V
	D	+6V	-6V	+6V	-6V

❖1: During MENU OFF, controls ZOOM/FOCUS and during MENU ON, changes the direction, Up, Down, Left, and Right.

2) When the voltage is supplied to both ports

DAY/NIGHT External Signal Input & Alarm Signal Output

This is a function to receive the external DAY/NIGHT signal from the sensor(option) and convert the signal into BW. An alarm signal is output from this terminal when the MOTION DET mode is activated or BW mode is activated.

DAY/NIGHT IN

1

GND E

2

ALARM OUT

Connect an external sensor to the DAY/NIGHT terminal as shown in ➀ then connect any external device such as a buzzer or lamp to the ALARM terminal as shown in ➁. The ALARM output terminal is an open collector with the following capacity: DC 16V and 100mA.

OFF : Open contact

ON : Below 100mA

The DAY/NIGHT input terminal has the input of DC 5V pull-up and over 0.2mA.

OFF : Open contact

ON : Closed contact

Function

Code

A

B

C

D

ENTER/AF ❖ 2		HOME RETURN ❖ 3
ZOOM Port	FOCUS Port	ZOOM Port	FOCUS Port
-6V	-6V	+6V	+6V
-6V	+6V	+6V	-6V
+6V	-6V	-6V	+6V
+6V	+6V	-6V	-6V

VIDEO OUT terminal

Connect the monitor's VIDEO IN. The video signal from the camera is transmitted to the monitor via this terminal.

RS485 terminal

RS485 remote control terminal.

Power LED

❖2: For short voltage supply during MENU OFF, executes AF and for more than 2 second

❖3: For more than 2 second long voltage supply, moves to the PRESET 0(HOME) position.

Lights when power is on.

POWER IN terminal

Plug in the power adapter here.

9 10