Samsung SR8730 CLEANING AND MAINTENANCE, _11, Robot, sofas and walls, thinner or alcohol, INFORMATION SAFETY, safety information _11

Vacuum cleaning Robot may not be able to continue itsNOTE operation if it is stuck at the entrance or veranda doorsill.

- Vacuum cleaning Robot stops operating for safety reasons if it cannot move for more than 5 minutes.

- To resume operating, turn the Power Switch off and then on again after moving it to a location where it can continue cleaning.

	Vacuum cleaning Robot cannot completely clean locations
NOTE	that it cannot reach, such as corners, and spaces between
	sofas and walls.
	- Please clean these locations occasionally.
	Dust clusters may remain after cleaning, when the vacuum cleaning robot fails to
NOTE	pick up dust clusters that were formed while cleaning.

-In this case, sweep up the dust with another cleaning tool.

CLEANING AND MAINTENANCE

When cleaning the product, do not spray water directly onto CAUTION the exterior or wipe it with a volatile material such as benzene,

thinner or alcohol.

- This may result in critical damage to the product.

Do not forcefully press the bumper on the Vacuum cleaning

CAUTION Robot.

- If the bumper sensor gets damaged, the Vacuum cleaning Robot may bump into walls or furniture.

The unit must not be disassembled or reconstructed by anyone CAUTION other than a qualified service engineer.

- This may result in damage to the product.

Remove any foreign substances accumulated on the Obstacle	Cliff sensor
WARNING and Cliff sensors on a regular basis.

- Dirt accumulated on the sensors will result in inaccurate functioning of the sensors.

Obstacle sensor

INFORMATION SAFETY 01

safety information _11