3Com 3C13840, 3C13759, 3C13701 manual Installing/Removing MIM, IV. Removing SIC, II. Installing MIM

3Com Router 5000 and Router 6000 v2.41

Module Guide Chapter 1 Overview

Figure 1-2Installing SIC

IV. Removing SIC

Follow these steps to remove a SIC:

Step 1: Place the rear panel of the Router towards you;

Step 2: Turn off the power switch of the Router and unplug the power cord;

Step 3: Unplug all the network interface cables connected to the rear panel of the Router;

Step 4: Remove the captive screws on both sides of the SIC using the flat-blade screwdriver;

Step 5: Pull the SIC outward until it is completely taken out of the Router chassis.

1.5.2Installing/Removing MIM

I.Tools required

z

z

Flat-blade screwdriver

ESD-preventive wrist strap and ESD-preventive glove

II. Installing MIM

Follow these steps to install a MIM:

Step 1: Place the rear panel of the Router towards you;

Step 2: Turn off the power switch of the Router and unplug the power cord;

Step 3: Select a slot and insert the MIM along the guides in the slot until it contacts the rear panel of the Router;

Step 4: Fix the MIM into the Router with captive screws;

Step 5: Power on the Router, and check the LEDs of the corresponding slot on the

front panel: ON means that the MIM is operating normally and OFF means that the POST of the MIM has failed. In the latter case, please contact your agent.

1-5