Regency P40-LP1 Installation, Manual Control Panel, Hinge, Screen, Right Side, Door, of Lower Air

INSTALLATION

Simply push in the Full Screen Door Frame until it aligns against the finished wall. Secure Top Flange of Full Screen Door Frame as described in step 4b.

For the Bottom Flange of the Full Screen Door Frame, push the bottom of the Frame until it aligns with the wall. Use the inner cutouts to secure the base of the Frame using the 2x #8 Hex Head Drill Point Screws provided.

8)Slide the Upper Air Register into the louver brackets located on the inside top of the firebox. Push in place.

INSTALLATION

Bottom Flange

Cut Outs

Rear view of Full

Screen Door Frame Shown

Upper Air Register

5)Re-install Glass Door. Refer to the manual for instructions (Page 32).

6)Place the Lower Air Register near hinges. Flip the two hinges over onto the Lower Air Register and

secure with 2x #8 Self Tapping Phillips Screws per	9) Install the Left and Right Side Screen Doors in the
side.	fully open position by placing over top of the hinges
	on the Full Screen Door Frame.
Hinge Location	NOTE: Failure to install the doors in the fully open
	position could result in paint damage to the surface
	of the door.

Lower Air

Register

7)Secure the Manual Control Panel to the Lower Air

Register with two #8 Self Tapping Phillips screws

(provided) at the right hinge bracket.

Manual Control

Panel

Hinge

	Hinge
	Bracket
	Screen
Right Side	Door
of Lower Air
Register	10) Close screen doors.

Regency® P40-1 Direct Vent Gas Fireplace 39