Regency P40-LP1 CONVERSION KIT #502-966FROM LP TO NG, If In Doubt Do Not Do This Conversion

INSTALLATION

CONVERSION KIT #502-966 FROM LP TO NG

THIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTER

IF IN DOUBT DO NOT DO THIS CONVERSION !!

INSTALLATION

NG Conversion Kit Contains:

Qty.	Part #	Description
1	910-463	NG Conversion Coil
1	910-036	NG Pilot Orifice
1	904-644	Orifice #35
1	904-568	Orifice #44
1	910-249	J9 Jumper
1	904-529	Allen Key
1	908-514	NG Conversion Decal
1	908-529	NG Yellow Label
1	918-719	Instruction Sheet

7)Remove the 2 screws on the back burner.

8)Slide the burner to the right and lift out.

12)Remove the pilot shield by removing the 2 screws.

1)Turn control knob to the OFF position; Shut off the gas supply to the valve; Unplug the power source.

2)Remove the louvers and the flush door.

3)Remove the logs.

4)Remove the Steel Fender, by loosening the retaining srews on both sides and slid- ing it out of place.

5)Remove the front air box by undoing the 3 screws.

Back Burner

9)Remove the front burner by removing the 2 screws. Lift the burner up and swing to the right and slide out.

Pilot Shield

13)Remove the pilot head from the assembly using a flat head screw driver to pop out.

Front Air Box

6)Loosen the air shutter adjustment screw and pull out the air shutter adjustment wire.

Front Burner

10)Replace the rear burner orifice with #35, using a 1/2" wrench. See image below. Use another wrench to hold onto the elbow behind the orifice.

11)Replace the front burner orifice with #44, using a 1/2" wrench. See image below. Use another wrench to hold onto the elbow behind the orifice.

Pilot Head

14)Remove the LP pilot orifice with theAllen Key and replace with NG pilot orifice. Reattach pilot head and clip.

		Rear Burner	Front Burner
Air Shutter	Air Shutter		Orifi ce
		Orifi ce
Adjustment Wire	Adjustment Screw

Regency® P40-1 Direct Vent Gas Fireplace 29