Regency P40-NG1 Venting Arrangements, Installation, AstroCap XL, Regency Direct Vent Flex System

INSTALLATION

INSTALLATION

VENTING ARRANGEMENTS

HORIZONTAL TERMINATION (FLEX)

Regency® Direct Vent System

These venting systems, in combination with the P40 Direct Vent Gas Fireplace, have been tested and listed as a direct vent heater system by Warnock Hersey. The location of the termination cap must conform to the requirements in the Vent Terminal Locations diagram in "Exterior Vent Termination Requirements" section.

Regency® Direct Vent (Flex) System			AstroCap XL
Termination Kit (Part# 946-618) includes all
			(Part# 946-623/P)
the parts needed to install the P40 with a
maximum run of 6 feet.
1)	8" dia. flexible liner (6 ft. length)
2)	5" dia. flexible liner (6 ft. length)
3)	spring spacers (4)	Wall Thimble
4)	thimble
		(required in Canada only)
5)	AstroCap XL termination cap (1)
6)	screws (12)		Vinyl Siding
7)	tube of Mill Pac (1)
			Standoff
8)	plated screws (8)
9)	screws #8 x 1-1/2" Drill Point,	5” dia. flue pipe
	Stainless Steel (4)
10) vinyl siding standoff		8" dia.
			spring spacer
If longer runs are needed, the Regency® Direct		Flue pipe

Vent system (Flex) Part# 946-616 includes all the parts needed to install the P40 with a maximum 10' run.

1) 8" dia. flexible liner (10 ft. length)

2) 5" dia. flexible liner (10 ft. length)

3)spring spacers (7)

4) thimble (2)

5)AstroCap XL termination cap (1)

6)screws (12)

7)tube of Mill Pac (1)

8)plated screws (8)

9)screws #8 x 1-1/2" Drill Point,

Stainless Steel (4)

10) vinyl siding standoff

Notes:

1)Liner sections should be continuous without any joints or seams.

2)Only Flex pipe purchased from FPI may be used for Flex installations.

3)Horizontal vent must be supported every 3 feet. (For 10' flex kit 946-616 only.)

14 Regency® P40-1 Direct Vent Gas Fireplace