FINISHING TRIM
NOTE: Install Finishing Trim prior to installing the Flush Door and Louvers.
1) Install the Finishing Trim sides as shown in diagram 1, line up the holes in the side trim with the holes in the firebox side.
2) Secure with 2 screws per side.
3)Loosen the 3 screws in the top inside edge
of the firebox.
4)Slide the Finishing Trim Top over the Side
Trim pieces and fit the bottom bracket slots |
|
over the screws. Tighten the 3 screws to |
|
secure. | Diagram 1 |
|
INSTALLATION
INSTALLATION
A receptacle is provided on the left hand side of the unit. 120 Volt AC power must be wired to the receptacle and the control module plugged in for the unit to operate fully. The front and rear burners will operate on low, when the unit is running on battery
WIRING DIAGRAM
(Do not cut the ground terminal off under any circumstances.)
Caution: Ensure that the wires do not touch any hot surfaces and are away from sharp edges.
CAUTION: Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and dangerous operation.
Regency® | 37 |