Regency P40-NG1 Summary Of Controls, Normal Operating Sounds Of Gas Appliances, Operation, Blower

OPERATING INSTRUCTIONS

OPERATION

SUMMARY OF

CONTROLS

For the Manual Control Box, located on right hand side of the bottom louver.

On/Off Button

If the unit is off, pressing and releasing this button once will switch the unit on. The unit will be on high for 20 seconds and then resume to its last settings.

If the unit is on, pressing and releasing this button once will switch the unit off.

Flame:

There are seven flame settings that can be adjusted by pressing and releasing the plus (+) and minus (-) FLAME button.

Increase: If the unit is on, pressing and releasing the flame plus (+) button once will increase the flame height to the next available high setting.

Decrease: If the unit is on, pressing and releasing the flame minus (-) button once will decrease the flame height to the next available low setting.

Fan:

There are three fan speeds that can be adjusted by pressing and releasing the plus (+) and minus (-) FAN button.

Pressing and releasing the plus (+) FAN button will change the fan speed as follows:

OFF -> LOW -> MEDIUM -> HIGH -> OFF

Pressing and releasing the minus (-) FAN button will be the reverse of the above.

FIREWIZARDTM REMOTE CONTROL FUNCTIONS

The FireWizardTM Remote Control was de- veloped to provide a user-friendly system to operate your appliance. The operating range is approximately 10 metres (32 feet) from the fireplace.

See FireWizard Remote Control Manual for complete details on operation functions and instructions.

NORMAL OPERATING

SOUNDS OF

GAS APPLIANCES

It is possible that you will hear some sounds from your gas appliance. This is perfectly normal due to the fact that there are various gauges and types of steel used within your appliance. Listed below are some examples.All are normal operating soundsand should not be considered as defects in your appliance.

Blower:

Regency® gas appliances use high tech blowers to push heated air farther into the room. It is not unusual for the fan to make a "whirring" sound when ON. This sound will increase or decrease in volume depending on the speed setting of your fan speed control.

*Note: Slight audible pauses may be heard when fan is operating. This is normal.

Burner Tray:

The burner tray is positioned directly under the burner tube and logs and is made of a different gauge material from the rest of the firebox and body. Therefore, the varying thicknesses of steel will expand and contract at slightly different rates which can cause "ticking" and "cracking" sounds. You should also be aware that as there are temperature changes within the unit these sounds will likely re-occur. Again, this is normal for steel fireboxes.

Pilot Flame:

While the pilot flame is on it can make a very slight "whisper" sound.

Gas Control Valve:

As the gas control valve turns ON and OFF, a dull clicking sound may be audible, this is normal operation of a gas regulator or valve.

Unit

On/Off

Button

Fan Control

Buttons

Flame

Control

Buttons

Unit Body/Firebox:

Different types and thicknesses of steel will expand and contract at different rates resulting in some "cracking" and "ticking" sounds will be heard throughout the cycling process.

Manual Control Box

42 Regency® P40-1 Direct Vent Gas Fireplace