10Connecting to the Wireless LAN

5.CONNECTING TO THE WIRELESS LAN

1.After you have configured the Router via the wired computer, you can connect to the Router via a wireless computer.

The Router and wireless clients must have both the same SSID and the same encryption settings. All wireless clients must use Infrastructure mode.

The default wireless settings for the Router are:

Service Area Name / SSID is 3Com

Channel 11

Encryption is off.

2.If you do not have a Wireless LAN you can use the Router’s default set- tings. Ensure that your wireless clients have the default SSID, channel and encryption as detailed above.

If you have an existing Wireless LAN, configure the Router to use the same SSID and and encryption settings to be compatible with your exist- ing wireless network.

Service Area Name/SSID

______________________________

Channel Number

______________________________

3.If your computer has both a wired and wireless NIC installed, you must ensure that only one NIC is used to communicate with the LAN. To use the wireless NIC, unplug the Ethernet cable and reboot your computer.

4.Launch your web browser and attempt to browse to an internet web site such as www.3com.com. If you can successfully access this site, then your wireless computer, Router and Cable/DSL modem have been success- fully configured.

5.3Com strongly recommends that you enable WPA encryption to improve the security of your wireless network and you change the SSID to some- thing other than the default. Consult the on line help or the User Guide for details.

Page 12
Image 12
3Com 3CRWER200-75, 3CRWER100-75 manual Connecting to the Wireless LAN