What’s New at Revision 8.2.0? | 13 |
|
| ||||
system |
|
|
|
| |
➧ethernet | summary |
|
| ||
fddi |
|
| |||
detail | s | ||||
tokenring | ➧fastEthernet | ➧duplexMode | |||
ifm | |||||
bridge | label | ||||
|
| ||||
ip |
|
| |||
portState |
|
| |||
snmp |
|
| |||
|
|
|
| ||
analyzer |
|
|
|
| |
script |
|
|
|
| |
logout |
|
|
|
|
To configure a port for
The
1From the top level of the Administration Console, enter:
ethernet fastEthernet duplexMode
You receive a prompt similar to the following:
Select slot(s)
This prompt indicates that the CoreBuilder 6000 system contains configurable Fast Ethernet ports in slots 10, 11, and 12.
2Enter the number(s) of the slot(s) that contain ports you want to set to
For each slot you entered, the system prompts you for specific port numbers:
Select Ethernet port(s)
3Enter the number(s) of the port(s) that you want to configure:
The system displays this message:
Warning: Changing mode to full duplex disables collision detection. The device connected to this port must be configured for the same duplex mode.
Do you want to change the duplex mode (n,y) [y]:
The CoreBuilder 6000 system does not support automatic negotiation of duplex mode between devices. You must configure any device attached to this port for the same duplex mode.
4Enter y for yes, n for no.
You receive the prompt to select each port’s duplex mode:
Enter new value (full, half) [half]: