6COREBUILDER 6000 INTELLIGENT SWITCHING SOFTWARE REVISION 8.2.0
To copy the software to a UNIX hard disk, follow these instructions.
If the directory “/usr/lp6000” does not exist on your computer, create the directory before proceeding. If your “/usr” directory is full, you can use a different directory. If you use a different directory, substitute the actual directory you use for “/usr” in this and subsequent procedures.
1Insert diskette #1 into the disk drive. These instructions assume drive rfd0.
2Extract the first part of the CoreBuilder software file using the following commands:
#tar xvf /dev/rfd0
3Remove diskette #1 using the following command:
#eject
4Insert diskette #2 into the disk drive and extract the second part of the file using the following command:
#tar xvf /dev/rfd0
5Remove diskette #2 using the following command:
#eject
6Insert diskette #3 into the disk drive and extract the third part of the file using the following command:
#tar xvf /dev/rfd0
7Remove diskette #3 using the following command:
#eject
8Insert diskette #4 into the disk drive and extract the fourth part of the file using the following command:
#tar xvf /dev/rfd0
9Remove diskette #4 using the following command:
#eject
10Insert diskette #5 into the disk drive and extract the fifth part of the file using the following command:
