3Com 6000 manual 4Next to User name, enter your user name

Loading System Software on the LMM+ 9

3Next to Install file pathname, enter the complete path and filename.

For MS-DOS system syntax, you must precede the full path with a forward slash ( / ). For example, if you are loading software from an MS-DOS host, enter the following command at the Install file pathname prompt:

/c:\lp6000\lp6000

4Next to User name, enter your user name.

5Next to Password, enter your password. You must enter a value for this field, although the field does not display what you enter.

Example of the software installation prompts on a UNIX system:

Host IP address [192.9.200.14]: 192.9.200.96

Install file pathname [/usr/lp6000/lp6000]:

User name: ronnyk

Password:

Programming flash memory block 1 of 24...

Programming flash memory block 2 of 24...

Programming flash memory block 3 of 24...

.

.

.

Programming flash memory block 24 of 24...

After the software is loaded, you receive this message:

Installation complete.

If the CoreBuilder executable software image stored in flash memory is corrupted (for example, when a power failure occurs while you are updating software), contact 3Com Technical Support. See “Technical Support” on page 30.

6To reboot the system to use the newly loaded software, enter:

system reboot

You are prompted with the following message:

Are you sure you want to reboot the system (y/n) [y]:

7 At the prompt, enter y for (yes).