3Com 6000 manual The power supply +5-voltinput has failed

20COREBUILDER 6000 INTELLIGENT SWITCHING SOFTWARE REVISION 8.2.0

Power Supply Warning Messages. This release of system software now displays these power supply warning messages when appropriate:

■+5V Failure

The power supply +5-volt input has failed.

■+12V Failure

The power supply +12-volt input has failed.

■+12V Restored

The power supply +12-volt input is restored.

■+5V Restored

The power supply +5-volt input is restored.

■Power Supply Over Temp

One of the power supplies has exceeded the allowable temperature of 90 degrees C.

SNMP Traps. When you insert and extract either of the power supplies, the system generates SNMP traps.

Hot-swappable Fans. You can remove and replace either of the two fans at the back of the chassis. When you remove a fan tray, the system generates a sound and the control panel displays the following message:

Fan Failure

Insert the new fan following the instructions and safety messages in the Installation Guide that comes with the new fan. The fan begins to function immediately after you install it. The system control panel displays this message:

Fan Restored