1
-
4
C
H
A
P
T
E
R
1:
B
R
I
D
G
E
/R
O
U
T
E
R
M
O
D
U
L
E
The principal features of the Bridge/Router Module are:
■
Easy to install, configure and support.
■
BRI B
ridge/Router Module – 2 x Basic Rate Interface ISDN, 2B+D port,
supporting Basic Rate interface of two 64 Kbps channels (or possibly two
56 Kbps channels in the USA) and a 16 Kbps control channel. Available
with a
U
or
S
ISDN interface.
■
PRI Bridge/Router Module– Primary Rate Interface ISDN supporting up
to eight 64 Kbps channels connecting to ISDN through the PRI
Interface Module.
■
Two leased line wide area network (WAN) access ports
.
The PRI Bridge/Router Module supports a total of eight ISDN/WAN ports. If
both WAN ports are to be used, only six ISDN channels can be connected
.
The maximum bandwidth of the Bridge/Router Module is 2 Mbps. If you
have a single leased-line link running at 2 Mbps connected to a WAN port,
you must disable the ISDN ports and the second WAN port.
■
Three standard Ethernet LAN connections.
■
Data terminal equipment (DTE) management port.
■
Support for full IP and IPX routing.
■
Protocol transparent bridging.
■
Sophisticated data packet filtering to provide network security.
■
Provides NetWare protocol
spoofing
.
■
Data compression based on an optimized Lempel Ziv algorithm.
■
Scalable R
outer Clustering (SRC) to optimize ISDN routing and line
usage.
■
Remote and local management.
■
Flash erasable programmable read-only memory (EPROM), allowing the
remote upgrading of the units operating system.
■
Uses simple network management protocol (SNMP) and provides
management information base (MIB) II support.