Setting Up a WAN Link
2-11
Setting Up a WAN Link
If you are using the Bridge/Router Module to connect to a remote site
over a leased line link, the initial setup is very simple.
1
Before you power on the unit, connect an appropriate WAN cable to
the WAN ports on the rear of the unit. If you have already powered on
the unit, switch it off and connect the cable.
For information about suitable cables, see
AppendixA
.
2
Power on the unit and connect to the management system.
3
Type CO
STD
and then confirm with Y
.
The unit automatically configures the WAN ports to the appropriate
line speed.
4
Refer to the
AccessBuilder ISDN Access Router Software Reference
guide
and edit the WAN port’s configuration as follows:
a
From the main menu, enter CO PO
.
b
Highlight the WAN port you want to edit.
c
Enter ED
to display the Edit WAN Port screen shown in
Figure 2-3
.
Figure2-3
Edit WAN Port Screen