Front Panel LEDs
2-9
CHAN 1 and 2
Channels 1 and 2 show the status of the two WAN ports,
WAN1 and WAN2. When lit, the LED shows that WAN port is configured
and up. When flashing, it shows that WAN port is configured and down.
ISDN
When lit shows that one or more ISDN channels are in use.
PRI FOUND
Indicates that a PRI Interface Module has been identified in
the chassis.
SRC MASTER
When lit shows that this module is the SRC master. If the
LED is flashing, it indicates a new SRC master is being chosen.
SRC SLAVE
When lit shows that this module is the SRC slave. If the LED
is flashing, it indicates a new SRC master is being chosen.
PWR
(Power) When lit indicates that the module is receiving power
from the chassis’ backplane and that the power circuits are functioning
correctly.
ALARM
Lights to indicate that an event has occurred which has been
configured to raise an alarm. See the
AccessBuilder 7000 Access
Concentrator User Guide
for more information.
ALERT
Lights to indicate that an event has occurred which has been
configured to raise an alert. See the
AccessBuilder 7000 Access
Concentrator User Guide
for more information.
TEST
Lights during the power-on self test.
LAN
When lit shows that LAN activity has been detected within the last
10 seconds. If the LED flashes, it shows the LAN is connected but no
activity has been detected for 10 seconds or longer.
MANAGER
When lit, a management terminal is connected to the module.
RUN
When lit indicates the module’s onboard software is running.
Push Buttons
Push both buttons together to reset the module and
restart it using the previously saved configuration.