Important Safeguards (Continued)
The "Up/Down/Lock" label, shown in Figure 1-8, is located on the top surface, on each side, of the upper column assembly. The label reminds the operator of the direction to turn the height adjustment crank to raise and lower the upper ski/taping head and the locking feature.
Figure 1-8 – Up/Down/Lock Label
The following two labels are located on the upper and lower taping heads. Replacement part numbers for these labels are listed in Section II.
The "Tape Threading Label", shown in Figure 1-9, is attached to the left side of both the upper and lower taping heads.
Figure 1-9 – Tape Threading Label
The "Warning – Sharp Knife" label warns operators and service personnel of the extremely sharp knife used to cut the tape at the end of the box sealing operation. The label, shown in Figure 1-10, is located on the orange knife guard between the applying roller assembly and the buffing roller assembly. Never operate taping head with knife guard removed.
Before working with the taping heads or loading/ threading tape, refer to Figures 3-1 and 3-2 in Section II to identify the knife location. Keep hands out of these areas except as necessary to service the taping heads or to load/thread tape.
Figure 1-10 – Knife Warning Label
