3M 200a manual Box Size Set-Up, 2 - Upper Taping Head -3 - Upper Taping Head, 4 - Side Guides

Operation (Continued)

Box Size Set-Up

1.ADJUST UPPER TAPING HEAD

The upper taping head is positioned for the box height by means of the height adjustment crank shown in Figure 3-2. Turn crank clockwise to lower head, counterclockwise to raise head.

Place box on infeed end of machine bed with both top and bottom flaps folded and insert under upper head ski approximately 150 mm [6 inch] as shown in Figure 3-3. Lower the head until all flaps are fully closed.

2.ADJUST SIDE GUIDES (Figure 3-4)

Align box top flap center seam with arrows on front of ski.

Move side guides against each side of box to hold box in position, centered on arrows on front of ski.

Tighten hand knobs to secure side guides.

Figure 3-2 – Upper Taping Head

Figure 3-3 – Upper Taping Head

Figure 3-4 – Side Guides

15