6
Important Safeguards (Continued)
The following two labels are located on the upper
and lower taping heads. Replacement part
numbers for these labels are listed below each
label.
The "Warning-Sharp Knife" label warns operators
and service personnel of the extremely sharp knife
used to cut the tape at the end of the box sealing
operation. The label, shown in Figure 1-11, is
located on the orange knife guard between the
applying roller assembly and the buffing roller
assembly. Never operate taping heads with knife
guard removed.
Before working with the taping heads or loading/
threading tape, refer to Figures 3-1 and 3-2 in
Section II to identify the knife location. Keep hands
out of these areas except as necessary to
service the upper taping heads or to load/thread
tape.
The "Tape Threading Label", shown in
Figure 1-12, is attached to the left side of both the
upper and lower taping heads. This label provides a
convenient tape threading diagram. More detailed
tape loading and threading information is provided
in this manual in the set-up procedure section.
Figure 1-12 – Tape Threading Label
Figure 1-11 – Knife Warning Label