11
Installation and Set-Up (Continued)
Figure 2-1 – Conveyor Bed Height Adjustment and Lower Tape Drum Bracket Position
BOX SIZE CAPACITY OF CASE SEALER
At its factory setting, the case sealer handles
box sizes up to 533 mm [21.00 in] maximum
height. If larger capacity is needed, the
machine can be adjusted to accommodate
boxes up to 644 mm [25.38 in] high. Refer to
page 24, "Special Set-Up Procedures – Outer
Column Re-positioning", for set-up procedure.

Note – Adjusting machine to accommodate 644

mm [25.38 in] high boxes also increases

minimum box size to 232 mm [9.12 in].

OUTBOARD TAPE ROLL MOUNTING (Lower
Taping Head Alternate Position)
Remove the tape drum bracket assembly,
spacer and fasteners from the lower taping
head. Install and secure on the infeed end of
the lower frame, as shown in Figure 2-1B.
TAPING HEADS
Tape Width – the taping heads have been pre-
set to accommodate 48 mm [2 inch] wide tape
rolls. To apply 36 mm [1.5 inch] or 42 mm
[1.75 inch] wide tapes, refer to Section II,
"Adjustments – Tape Web Alignment", page 11.
Tape Leg Length – taping heads are pre-set to
apply 70 mm [2.75 in] long tape legs. To
change tape legs to 50 mm [2.0 inch], refer to
"Special Set-Up Procedure – Changing Tape
Leg Length", page 24.