28
Changing the Tape Leg Length
(From 70 to 50 mm [2-3/4 to 2 inch])
Special Set-Up Procedure
Figure 6-1 – Case Sealer Frame Changes
The following changes to the case sealer frame and upper/lower taping heads reduces the tape leg length to
50 mm [2 inch] and also allows the taping of boxes 95 mm [3.75 inch] minimum height.
CASE SEALER FRAME
(Refer to Figure 6-1A)
1. Raise and latch upper drive assembly in upper position. Turn off air supply and electric power.
2. Remove and retain the screws, washers and bumper support assembly on both side columns. Remount and
secure the bumper support assemblies using the top holes and original fasteners.
3. Be sure adjustable split collars on column cylinder rods are loose or clamped at the top of the cylinder rod to
allow the upper drive assembly to descend fully.
•To reduce the risk associated with mechanical and electrical hazards:
−Turn electrical and air supply off and disconnect before performing any adjustments, maintenance or
servicing the machine or taping heads
WARNING