12
Installation and Set-Up (Continued)
Figure 2-1 – 700r3 Frame Set-Up
9. Cut and remove cable ties on both upper and
lower taping heads. (Applying/buffing rollers are
held retracted for shipment.)
Hold taping head BUFFING ROLLER and cut
and remove cable tie that holds applying/buffing
arms retracted. See Figure 2-1C. Allow buffing/
applying arms to extend slowly.
Also cut and remove cable tie at rear of lower
taping head.
10. Check for free action of both upper and lower
taping heads.
Push buffing roller into head to check for free,
smooth action of taping heads.
11. Ensure that the tape drum bracket assembly,
located on the lower taping head, is mounted
straight down, as shown in Figure 2-5A. The
tape drum bracket assembly can be pivoted to
provide tape roll clearance in certain cases.
12. Remove fasteners that secure case sealer legs
to pallet.
•To reduce the risk associated with sharp
blade hazards:
−Keep hands and fingers away from tape
cutoff blades under orange blade guards.
The blades are extremely sharp
WARNING
•To reduce the risk associated with sharp
blade hazards:
−Keep hands and fingers away from tape
cutoff blades under orange blade guards.
The blades are extremely sharp
WARNING