3M M170 Installing the Video Card and Video Driver, Supported Video Display Modes and Refresh Rates

Chapter 2 Setting Up Your M170 FPD Monitor 17

Figure 8. Adjusting the Viewing Angle

Lift up latch to release lock and raise or lower display to suit your needs.

Push down latch to engage lock and stabilize display position.

Lift up on the latch to release lock. Adjust the M170 FPD by pushing or pulling on the top front of the monitor until the screen is at the best viewing angle for you. Then push down on latch to engage locking mechanism and stabilize display position.

Installing the Video Card and Video Driver

Before you can connect your touch monitor, make sure your computer has a video card and driver already installed for the monitor. The video driver is supplied by the video card manufacturer and may be found on the disks that came with your computer. If you need information on installing a video card or video driver, refer to your computer documentation for instructions.

Supported Video Display Modes and Refresh Rates

Your video card should support one of the display modes specified in Table 1. If you select an unsupported video mode, the monitor may stop working or display unsatisfactory picture quality.

3M Touch Systems Proprietary Information