20M170 FPD Monitor Installation Guide

Table 2. Supported Mag Stripe Card Readers

 

ID Tech®

MagTek®

all MiniMag™ readers

all "mini" sized

 

 

 

readers

IDT 3331-02U

 

IDT 3321-33

2180201

IDT 3331-12U

 

IDT 3321-33PP

2180202

IDT 3331-23U

 

IDT 3331-02

2180203

IDT 3331-33U

 

IDT 3331-12

2180204

IDT 3321-02

 

IDT 3331-23

2180205

IDT 3321-02PP

 

IDT 3331-33

2180206

IDT 3321-12

 

IDT3301-02

21040103

IDT 3321-12PP

 

IDT3301-12

21040104

IDT 3321-23

 

IDT3301-23

 

IDT 3321-23PP

 

IDT3301-33

 

Connecting the Touch Monitor

CAUTION

You are cautioned that any change or modification to the equipment not expressly approved by the party responsible for compliance could void your authority to operate such equipment.

The M170 comes with the cables already connected (with the exception of the audio cable), however, there may be times when you need to reconnect these cables for some reason. To connect the M170 FPD monitor:

1.Turn off your computer. You should always turn off the computer before connecting or disconnecting any device.

Figure 11. Identifying Your Monitor Connections

Headphone

Line In

Power

Video Connection

Touch Screen

 

 

 

 

 

2.Connect one end of the video cable to the video connector on the FPD. Connect the other end to the video card in your computer.

3.Connect one end of the touch screen cable (either serial or USB) to the FPD. Connect the other end to an available port on the back of your computer. If you are using a USB connection, make sure you have installed the TouchWare drivers prior to connecting the touch screen cable.

3M Touch Systems Proprietary Information