ENGLISH
Section 3: Basic Operations
3.1 Projector Startup
|
|
| – ZOOM + | – FOCUS + |
|
|
| MUTE | INPUT |
I |
|
| MENU |
|
|
|
|
| |
O |
|
| STANDBY ON | RESET |
|
|
| ||
|
|
| POWER LAMP | |
|
|
| TEMP | |
| RESET |
|
|
|
+ | INPUT | MENU |
|
|
|
|
|
| |
| + | MUTE |
|
|
|
|
|
| |
|
| PROJECTOR |
|
|
|
| MP8745 | PORTABLE |
|
MP8745 |
|
|
|
|
Figure 3.1 Projector Controls
1.Make all cable connections and line hookups with the power off.
2. | Turn the POWER SWITCH | I | of the projector on. The POWER indicator will light up orange. |
O | |||
| |||
|
|
| STANDBY ON |
3. | Press the STANDBY/ON button | . The POWER indicator blinks (green) and then lights (green). | |
The POWER indicator will blink green during
4.Adjust the screen size by pressing the ZOOM button. – ZOOM +
5.Adjust the focus by pressing the focus button. – FOCUS +
Press any other button to make the focus screen disappear.
6.Turn on all connected equipment. Refer to section 2.3.
7. Press the INPUT button | INPUT |
on the projector or the INPUT SELECT (VIDEO or RGB) button on the |
remote to select the source of the signal to be projected on the screen. The selected signal input is displayed at the bottom right of the screen. The display will show the last selected input source before power was turned off.
3.2 Projector Shutdown
STANDBY ON
1. Press and hold the STANDBY/ON button 
for 1 second. The POWER indicator blinks orange and the lamp turns off. After approximately 1 minute, the fan stops and the indicator stays orange.
2. Turn the MAIN POWER SWITCH | O I | of the projector off. |
|
|
|
|
| Caution |
Do not turn off the POWER SWITCH before pressing the STANDBY/ON button. After the STANDBY/ON button is pressed, the fan rotates for about 1 minute to cool the projector.
3.Attach lens cap to protect projection lens.
4.Disconnect cables if moving projector to new location.
12 | 3M™ Multimedia Projector MP8745 | © 3M 1999 |
