3M MP8780 manual Basic Operations, Projector Startup, Projector Shutdown

ENGLISH

Section 3: Basic Operations

3.1 Projector Startup

Menu + + +

RGB

Select Zoom Focus Volume Standby/On

– – – Blank Video

O I

O I

Figure 3.1 Projector Controls

1.Make all cable connections and line hookups with the power off.

2. Turn the POWER SWITCH O I of the projector on. The ON indicator will light up orange.

3.Press the STANDBY/ON button Standby/On . The ON indicator blinks (green) and then lights (green). The ON indicator will blink green during warm-up and lamp ignition. When power is turned off, there is a 90 second reset period before the STANDBY/ON button will function again.

4.Adjust the screen size by pressing the ZOOM +/- button.

5.Adjust the sharpness by pressing the FOCUS +/- button.

6.Turn on all connected equipment. Refer to section 2.3.

7.Press the RGB/VIDEO button on the projector or remote to select the source of the signal

to be projected on the screen. The selected signal input is displayed at the top right of the screen. The display will show the last selected input source before power was turned off.

3.2 Projector Shutdown

1. In projection mode, press the STANDBY/ON	button. The Shut Down screen will display. Select
	Standby/On

the

YES option (press arrow button or mini-joy stick) to turn off. The fan will continue to run for approximately 90 seconds.

2.Turn the MAIN POWER SWITCH

O I

of the projector off.

Caution

Do not turn off the POWER SWITCH before pressing the STANDBY/ON button. After the STANDBY/ON button is pressed, the fan rotates for about 90 seconds to cool the projector.

3.Attach lens cap to protect projection lens.

4.Disconnect cables if moving projector to new location.

12 3M™ Multimedia Projector MP8780 © 3M 1999