Installation
Your Model 392 telephone can be installed on a desk or mounted on the wall. To use the phone’s Call Waiting and Caller Identification capabilities, contact your local Service Provider for subscription details. Your Service Provider may call these services by different names.
Note: : In order to properly install this telephone for two line use, you will need to know if your two telephone lines originate from a single tele- phone jack or from two sepa- rate jacks. See the diagram in step 5 "Install the phone". Use the two line adapter (included with this phone) for installation if your two lines originate from two separate jacks.
1. Connect the handset cord
Turn the telephone over and locate the handset jack marked j. Insert one end of handset cord into the jack until it clicks into place. Then route the handset cord through the groove as shown in the illustration below.
Attach the handset to the other end of the handset cord.
1
B
A
2
Handset groove
Handset cord Handset
2. Attach the stand
If you plan to mount the phone on the wall, you do not need to attach the stand; skip this step. If you plan to use the phone on a desk, attach the stand by inserting the tabs on the stand (marked with o) into the slots on the bottom of the telephone
(A). For a higher viewing angle, use the slots marked n. For a lower viewing angle, use the slots marked m. Then slide the stand towards the phone until it snaps into place (B).
3. Connect the cords
If you attached the stand to install the phone on a desk, route both the phone cord (or the cord attached to the two line adapter) and power adapter cord through the opening in the stand. Insert the phone cord into the slot on the back of the telephone marked l until it clicks into place. Insert the power cord into the power jack marked k.
Note: You should connect the power adaptor to a surge pro- tector or power bar.
4. Press the cords into grooves
Press the cords into two of the grooves provided on the bottom the stand. This will allow the stand to sit flat on a desk surface.
5. Install the phone
If you have installed the stand and are using the phone on a desk: Simply turn the telephone over so it rests on the stand. If both phone lines originate from a single jack, use diagram I for final installation. If the two phone lines originate from two separate jacks, use diagram II for final installation.
Installation
Model 392 User Guide 4
