Aastra Telecom ATP-CNX-020 setup guide Prepare for hardware installation

Aastra CNX Quick Installation and Setup Guide

Procedures

Preparing for the hardware installation

1 Prepare for hardware installation

What you need for a single installation

One Aastra CNX unit One AC power cable

One CompactFlash memory card

One set of rack mounting brackets with six (6) Phillips head screws Truss head screws (not provided)

One to four RJ-48C T1/E1 cable(s) (not provided)

NOTE: T1/E1 Ports 1 and 2 are available for the 30-port unit and the 60-port unit. One 9-pin male DB-9 to female DB-9, RS-232 serial cable

One or two RJ-45 10/100BaseT Ethernet cable(s) (not provided) (Optional) One 9-pin male DB-9 to female DB-25, RS-232 serial cable for modem connections (not provided)

*Tools required for rackmount installations

In addition to the parts listed above, the following tools are also required when installing an Aastra CNX rackmount unit:

#2 Phillips screwdriver Torque wrench Nutdriver set

Check the shipping contents

Upon opening the shipping package, inventory the contents to be sure there are no missing or damaged parts, as described in the Welcome section of this document.

Determine location of Aastra CNX (desktop or rackmount)

a.If you are installing the Aastra CNX as a desktop unit, place it on a flat surface in close proximity to your PC, skip Step 2, and perform Steps 3 through 8.

b.If you are installing the Aastra CNX as a rackmount unit, proceed to Step 2.

2 ATP-CNX-020 Rel. 1.2, Doc. Rev. 01.06