3-4

Chapter 3

 

 

!User Defined

%%%% Warning %%%%

The wrong settings of the multiplier and external clock in certain circumstances may cause CPU damage

The wrong settings of the multiplier and external clock in certain circumstances may cause CPU damage. Setting the working frequency higher than the specifications of PCI or of processor may cause abnormal memory module functioning, system hangs, hard disk drive data loss, abnormal functioning of the VGA card, or abnormal functioning with other add-on cards. Using non-specification settings for your CPU is not the intention of this explanation, for which should be used for engineering testing only, not for normal applications.

If you use non-specification settings for normal operation, your system may not be stable, and may effect system reliability. Also, we do not guarantee the stability and compatibility for settings that are not within specification, and any damage of any elements on the motherboard or peripherals, is not our responsibility.

"CPU FSB Clock (MHz):

You can increase the CPU FSB clock speed here. This means that you can independently increase the CPU FSB clock speed. The DEC (decimal) numbers from 100 to 250 are available, with the default setting at 100. You can change this setting to increase CPU FSB clock speed. CPU FSB speed above the standard bus speed is supported, but not guaranteed due to the CPUspecs.

"Ratio (FSB:AGP:PCI):

Three options are available: 3:2:1 ( 4:2:1 ( 5:2:1. This item lets you set the processor Front

Side Bus, AGP and PCI clock. It correlates with the processor FSB clock you set. Many of options are available, you can choose the divider ratio you want. If the setting is 3:2:1. In this case, the AGP clock will be the processor FSB clock divided by 3 and times 2. The PCI clock will be the processor FSB clock divided by 3 and times 1.

Note: According your processor FSB frequency, the default values will change also.

"Multiplier Factor:

Three are several settings, shown as below:

!x5

!x5.5

!x6

!x6.5

!x7

!x7.5

!x8

!x8.5 !x9

!x9.5

!x10

!x10.5

!x11

!x11.5

!x12

!x12.5/13

!over x13

"Enhance For Benchmark:

Two options are available: Disabled ( Enabled. The default setting is Disabled. This item can improving your processor and system performance.

"Speed Error Hold:

Two options are available: Disabled ( Enabled. The default setting is Disabled. If you change the setting to Enabled when the CPU speed setting is wrong, the system will hold.

Normally, we do not recommend that you use the “User Define” option to setup CPU speed and PCI clock. This option is for setup of future CPUs whose specifications are still unknown. The specifications of all present CPUs are included in the default settings. Unless you are very familiar with all CPU parameters, it is very easy to make mistakes when you define the external clock and the multiplier factor by yourself.

AT7/AT7E