Quick Installation Guide
Authentication Type
You may choose either the Open System or the Shared Key. (Default: Open System)
If Shared Key is enabled, WEP should be enabled and at least one shared key should be defined. But you can enable WEP, and set the authentication type as Open System.
Standard WEP Setup (WEP Default: Disable)
Default Shared Key – Choose the Shared Key that has the encryption string you prefer (Key 1~4 for
Note: All wireless devices must have the same Key ID values to communicate.
Key Length (Manual Entry) | Hex Digits per Key ID |
|
|
10 HEX digits |
26 HEX digits
32 HEX digits
Advanced WEP Setup
How to set up the Unique Key WEP:
1.Select a unique key (5 ~ 64)
2.Enter the encryption key and select the proper key size.
3.Click Write and Apply to save the encryption key.
4.If you want to read an encryption key, select the unique key you want to read, then click Read and Apply to view the encryption key.
5.If you want to delete an encryption key, select the unique key you want to delete, click Delete and Apply to delete the encryption key.
Using Access Control List
Set the Access Control List (ACL) to filter out specified MAC addresses. The ACL provides a mechanism to take certain actions based on the stations MAC address. Any frames with a source or destination MAC address entered in this table will be filtered from the access point.
18
